Functional Description - Makita DDG460 Instruction Manual

Installing the side handle
Remove the bolts shown in the figure from the tool.
The removed bolt is not needed for this tool if you want
to use this tool as a cordless earth auger.
Keep the bolts so that they are not lost.
1
► 1. Bolt
Place the side handle on the tool.
Tighten the all four bolts temporarily, and then securely
tighten the bolts using the wrench.
3 2
1
► 1. Side handle 2. Bolt A 3. Bolt B
1
3
Installing the reaction receiver
Place the reaction receiver so that the bar of the reac-
tion receiver comes to the left side of the operator.
Adjust the position of the reaction receiver so that the axis
of the drill chuck is in the center of the operator's body.
Fasten the bolts firmly.
1
► 1. Bar of the reaction receiver 2. Bolt C

FUNCTIONAL DESCRIPTION

CAUTION:
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
2
► 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
7 ENGLISH
2
1
Always be sure that the tool is
1
2
2