Homepatrol-2 Operations; Start-Up Wizard; Selecsng Channels To Monitor; Change Locason - Uniden HomePatrol-2 Owner's Manual

HOMEPATROL-2 OPERATIONS
Start-Up Wizard
The first Sme you turn on your HomePatrol-2, it will take you through a startup wizard to install the
HomePatrol SenSnel sodware and set up basic scanning criteria. To run the startup wizard again, tap and
hold the Help bueon.
Running the Startup Wizard
1. Plug the provided USB cable into your computer and into HomePatrol-2's USB jack.
HomePatrol-2's screen turns white during PC connecSon. When connected to the PC,
HomePatrol-2 installs like an addiSonal drive.
2. Allow the installaSon to Autorun. If you don't see an Autorun prompt, open the drive and
navigate to the setup.exe file in the Setup folder. Double click setup.exe to run that program.
3. SenSnel will ask you where you want to install the sodware. Once the sodware is installed, click
Close when prompted.
NOTE: Sen%nel uses the internet to check for firmware and radio data updates.
4. Ader installing SenSnel, disconnect HP from the PC. HomePatrol-2 restarts iniSalizaSon.
Selecting Channels to Monitor
HomePatrol-2 operaSons revolve around the ability for you to listen to the transmissions you want to.
There are many ways to fine-tune the transmissions your HomePatrol-2 receives:
Change your locaSon
•
Select service types
•
Change the Range
•
Select Favorites Lists to use
•
Avoid transmissions
•
While HomePatrol-2 selects channels, the Channel SelecAon screen appears. For the first 5 seconds, the
screen shows the message "0 Channels Selected" with Cancel (acSvated) and Other OpAon (deacSvated)
in the Feature NavigaSon bar. Ader 5 seconds, the screen shows the number of channels selected,
increasing as more channels are selected. When channel selecSon completes, Other OpAons is acSvated
and Cancel changes to Listen.
If you select Other OpAons at this point, you can choose to take any of the acSons listed previously
except Avoid transmissions.
If your selecSon results in many channels, your HomePatrol-2 will warn you that it will take a long Sme
to scan through all selecSons and recommend that you change your criteria to reduce the number of
channels selected.
Change Location
There are five ways to change your locaSon from the Menu screen:
11