Panasonic AW-HE40 Manual page 4

2．AW-HS50 Audio Settings
* In order that the audio superimposed on an SDI input signal is can pass through, the setting change below is required.
① Hold down OSD ON button – (Fig.5-A) for 2 seconds to open the menu. (Hold it down again for 2 seconds to
close the menu.)
② Use OSD/TIME dial – (Fig.5-B) to set the settings for individual output signals you want to allow to pass through.
Menu: ［14］SYSTEM Menu – (Figure 6) ＞ ［Set the settings for output signals individually. – (Figure 7)］
<Note>
・You cannot fix and continue to output the audio of a specific input. When the video is switched, the audio is
also switched together.
・Even if an SD signal is input in DbyD or UC mode while AW-HS50's format setting is 1080/59.94i, 720/59.94p
or 1080/50i, the audio is not allowed to pass through.
(Figure 5: AW-HS50 Control Panel)
(*1) If PGM bus or others are selected for the AUX output signal, only the [On] setting of "4. AUX Anci" is not enough
for the audio to pass through.
When the following buses are selected, please change their settings in addition to "4. AUX Anci [On]".
・PGM is selected as a source. ⇒ 5．PGM Anci ［On］
・PVW is selected as a source. ⇒ 6．PVW Anci ［On］
・MV is selected as a source. ⇒ 7．MV Anci ［PGM or PVW］
* If a selected source is KEY_OUT or CLN, the audio will not pass through.
4．For allowing the audio of a source selected at AUX buss to pass through: ［On］(*1)
5．For allowing the audio of a source selected at PGM buss to pass through: ［On］
6．For allowing the audio of a source selected at PVW buss to pass through: ［On］
7．Setting for the output signal for Multi View Display
For allowing the audio of a source selected at PGM bus to pass through: ［PGM］
For allowing the audio of a source selected at PVW bus to pass through: ［PVW］
（B）
（A）
(Figure 6: AW-HS50 Menu Display Screen)
(Figure 7)
* Screen shows default settings