AEG 67670 K-MN User Manual page 57

flashes
is lit
and number are displayed
and minus are displayed
If you are unable to remedy the problem by following the above sugges
tions, please contact your dealer or the Customer Care Department.
1
Warning! Repairs to the appliance are only to be carried out by qualified service
engineers. Considerable danger to the user may result from improper repairs.
3
If the appliance has been wrongly operated, the visit from the customer service
technician or dealer may not take place free of charge, even during the warranty
period.
Problem Possible cause
Unsuitable cookware
No cookware on the cooking
zone
The diameter of the bottom of
the cookware is too small for
the cooking zone
Overheating protection for the
cooking zone has been trig
gered
Automatic switch off has been
triggered
Electronics fault
Light rays that are too strong
on the control panel, for ex
ample bright sunlight
What to do if ...
Remedy
Use suitable cookware
Place cookware on the cooking
zone
Move onto a smaller cooking
zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system)
If after switching on again,
is displayed again, call the cus
tomer service department
Briefly shade the control pan
el, for example with the hand
Acoustic signal sounds, appli
ance switches itself off Switch
appliance on (again)
57