Use With Other Personal Protective Equipment; Disclaimer - Point Two ProAir2 Adult User Manual

CONCLUSION
Check again to ensure accurate reassembly of the airbag trigger system bearing in mind your own safety.
Any exterior or interior damage could cause a malfunction.
Thoroughly following these instructions will ensure your Point Two body protectors' airbag system is
properly reset. If, however, you remain unsure about the resetting procedure, or are not confident of your
understanding of these instructions, please visit the Point Two website to view the instructional video, or
for one-to-one assistance, speak with the supplying retailer, or contact Point Two direct.

11. Use with other Personal Protective Equipment

Body protectors are part of the protective equipment ensemble available for use by horse riders, and are
intended to be used with a safety helmet meeting an appropriate standard, with fitted or separate eye
protection where there is a risk of eye injuries.
Where this body protector features attachment points for fitment of shoulder protectors, it is strongly
recommended that where these are worn, they are also type approved and CE marked in accordance with
the requirements of EN 13158:2009, or other documents of equal status.
For added protection, Point Two Vests (ProAir2, Hunter and Soft Shell) can be worn over an EN 13158 body
protector.

12. Disclaimer

• Please note, no body protector can prevent death or serious injury in certain accidents.
• Point Two Ltd will be held in no way responsible for any bodily injury or death, and/or property damage
that may occur whilst using any Point Two product.
• Point Two Ltd accepts no responsibility or liability for any improper installation and usage of any of its products.
• All Point Two air jackets are rigorously tested before being sold. Every jacket is inflated to double the
pressure as it would be when inflated normally, however we cannot guarantee the jacket will inflate every
time or be held responsible should it not.
• Point Two requires that all jackets are serviced annually, after every 6 inflations, a particularly
heavy fall, or a fall into water.
• This product has been CE certified under the name of Point Two by: SATRA Technology Centre, Satra
House, Rockingham Rd, Kettering NN16 9JD
• The Point Two jacket protects only when inflated.
14
J Insert the CO 2 cartridge into the trigger body. If you encounter resistance,
ensure you have correctly aligned the location lug on the bayonet fitting with
the insertion slot on the trigger body.
K Using light downward pressure, twist the CO 2 cartridge clockwise to the
left, as shown by the direction of the top yellow arrow in the picture, until the
location lug on the bayonet fitting is in the left side of the location slot.
L Provides a close up of the correct final position for the location lug in the
trigger body location slot.
M Close the zip on the CO 2 cartridge cover.