Starting A Washing Programme - Zanussi ZDT 6255 Instruction Book

Starting a washing programme

In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off button
All the indicator lights of the programme selection buttons
illuminate.
4. Setting and starting the programme
To select a programme, press the programme button of
the washing programme you wish to select (see
"Washing programmes" chart).
The corresponding indicator light remains illuminated
while the other programme buttons indicator lights turn off.
Close the dishwasher's door, the programme will start
automatically.
Setting and starting the programme with the
«delay start»
To select a programme, press the programme button of
the washing programme you wish to select (see
"Washing programmes" chart).
The corresponding indicator light remains illuminated
while the other programme buttons indicator lights turn off.
Press the DELAY START button until the indicator light
corresponding to the chosen hours flashes (3 h, 6 h or 9 h).
Close the dishwasher's door, the countdown starts
automatically and will decrease with steps of 3 hours.
The opening of the door will not modify or interrupt the
countdown. Once the delay start has elapsed the
programme will start automatically.
NOTE:
The start of the programme or the countdown of
the delay start will occur only after the closure of the door,
until this moment you can modify the selection made.
5. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it's absolutely necessary
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
Interrupt a washing programme in progress
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point at
which it was interrupted.
Cancel a washing programme in progress
Open the dishwasher door.
Press simultaneously the function buttons 2 and 3 for
about 2 seconds, the indicator light of the button
corresponding to the running programme starts flashing for
about 2 seconds.
After about 2 seconds the indicator lights of all the
programme buttons will illuminate indicating that the
running programme has been cancelled and that the
machine has returned to setting mode.
(If a new washing programme will be selected, check that
there is detergent in the detergent dispenser).
6. To cancel a delay start in progress
Open the dishwasher door and press the delay start
button until the indicator lights corresponding to the hours
(3 h, 6 h, 9 h) are off.
The selected washing programme will start automatically
after the closure of the door.
7. End of the washing programme
The dishwasher will automatically stop and an audible
signal informs you of the end of the washing programme.
Open the door, leave it ajar and wait a few minutes before
removing the dishes; in this way they will be cooler and the
drying will be improved.
The END OF CYCLE indicator light is illuminated.
The indicator light of the programme just ended remains
on.
Switch off the dishwasher by pressing the On/Off button.
8. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
13