Operation - OK. OTF 3331 W User Manual

ASSEMBLY OF REAR GUARD
1 If still attached, remove the fan blade nut and plastic nut (LOOSEN). Attach the rear guard to the
motor housing with the handle facing up and the screw hole facing down, align with the pins.
Secure the rear guard with the plastic nut (TIGHTEN).
2
ASSEMBLY OF FAN BLADE
Slide the fan blade onto the motor shaft so that the pin locks to the groove.
3
Secure the fan blade with the fan blade nut.
4
ASSEMBLY OF FRONT GUARD
5 Open the clips and remove the screw and nut, hook the front guard from top onto the rear guard,
aligning both screw holes.
Install the screw and nut at the lower side to lock the guards.
6
Close the clips.
7
ASSEMBLY OF BASE
Push the motor unit into the base and ensure that it is firmly pressed into the base and correctly
8
engaged.
Fix the motor unit and base from bottom side with the 4 screws provided.
9
Caution:
• The product may only be connected to the mains once it has been completely assembled.
• The product must not be disassembled during operation, general care, cleaning and user
maintenance.
• The product may never be operated without the stand or in a horizontal position.
Note: Switch off and disconnect the product before adjusting the angle.

OPERATION

Note: Place on an even stable surface.
10 For oscillation function, push the oscillation knob down. Pull knob to stop the oscillation.
11 Set the desired angle.
12 Plug in the product.
13 To switch the product on, press speeds 1-3. To switch it off, press 0.
14 Unplug if it is not used for some time.
Caution:
• The guard must be completely closed when operating the product.
• During operation, do not put fingers or other objects in the guard.
IM_OTF3331_161101_V03_HR.indb 13
13
EN
1/11/16 11:29 AM