Table 1-5. Pinouts For Connector J2; Table 1-6. Mxh Cable Options - Aerotech MXH Series Option Manual

Description and Configuration
Table 1-5.
Table 1-6.
Cable
MXC-xx
BFCMX-xx
DC-DDMX-xx
DC-MSOMX-xx
PFCMX-xx
"xx" is the available length in feet
1-10
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Pinouts for Connector J2
Pin Signals
1 Shield Grounded when connected to an interface board.
2 Tied to J1-2
3 Encoder +5V Supplies 5V to motor encoder through J1, pin 3.
4 Ground Supplies ground to encoder, tied up with J2, pins 20, 21.
5 Hall Effect B Brings Hall signal directly from motor to interface board
through J1, pin 5.
6 Marker - Multiplied RS-422 out from MXH to interface board.
7 Marker + Multiplied RS-422 out from MXH to interface board.
8 Output option dependent. See Section 1.4.8. (also Figure 1-12
through Figure 1-15).
9 Output option dependent. See Section 1.4.8. (also Figure 1-12
through Figure 1-15).
10 Hall Effect A Brings Hall signal directly from motor to interface board
through J1, pin 10.
11 Hall Effect C Brings Hall signal directly from motor to interface board
through J1, pin 11.
12 CW Limit Brings Hall signal directly from motor to interface board
through J1, pin 12.
13 Output option dependent. See Section 1.4.8. (also Figure 1-12
through Figure 1-15).
14 COS + Multiplied RS-422 out from MXH to interface board.
15 COS - Multiplied RS-422 out from MXH to interface board.
16 +5V Supplies 5V from the interface board to MXH, tied to J1, pin
16.
17 SIN + Multiplied RS-422 out from MXH to interface board.
18 SIN - Multiplied RS-422 out from MXH to interface board.
19 Output option dependent. See Section 1.4.8. (also Figure 1-12
through Figure 1-15).
20 Ground Supplies ground to encoder, tied up with J2, pins 4, 21.
21 Ground Supplies ground to encoder, tied up with J2, pins 4, 20.
22 Home Limit Brings Home Limit directly from motor to interface board
through J1, pin 22.
23 Output option dependent. See Section 1.4.8. (also Figure 1-12
through Figure 1-15).
24 CCW Limit Brings CCW Limit directly from motor to interface board
through J1, pin 24.
25 Output option dependent. See Section 1.4.8. (also Figure 1-12
through Figure 1-15).
MXH Cable Options
Description
MXH to controller cable
MXH to motor or controller cable
ADR to MX box feedback cable
DC Brush Motor to MXH cable
MXH to (controller) flying lead cable
Aerotech, Inc.
MXH Multiplier Option Manual
Description
Version 1.6