Operating The Antenna; Remote Control - Ten-Haaft Premium OYSTER 65 Instructions For Use Manual

1. CONTROL ELEMENTS
Please note: When you switch the primary TV set on, it immediately resumes priority over the control commands.
The system will provide an image to the primary TV set. When you switch the primary TV set off, the antenna will
retract. To prevent retraction, use the "Open Sleep" function (see section 2.2 / page 15).
If in the meantime the antenna has received a control command via the app, then the primary TV set may no
longer show an image (e.g. if the antenna has been moved into a different position using the app). To resume
antenna control, press the START button on the primary TV set's remote control. The antenna will then move back
into its initial position and the TV set will show an image.

1.2 Operating the antenna

If the antenna system is set up in the normal manner, it is not necessary to operate the antenna. The system
will find the corresponding satellite automatically. If the position has changed significantly since last use, it is
recommended to use the COUNTRY button to enter the current position.
The antenna function is controlled by the following 4 remote control buttons:
Country button: For the entry of the current position in order to optimise the satellite search.
Stop button; Start button; Park button – for the direct operation of the antenna.
When the receiver integrated in the "Oyster® TV" Premium device is switched off, the antenna buttons are not
operational. The other buttons on the remote control can be used to control the receiver integrated in the "Oys-
ter® TV" Premium system. See point 1.3 "Remote control". The "Oyster® TV" Premium system is configured at the
factory to control the antenna.
4
1. CONTROL ELEMENTS

1.3 Remote control

Taste Funktion
0 - 9
EPG
EXIT
TIME
SHIFT
SWAP
SOURCE
FILE
OK
CHANNEL
POWER: In standby mode, this button will switch the
"Oyster ® TV" with integrated receiver into operating mode.
0 – 9 NUMBER BUTTONS: Press one of the number but-
tons (0 – 9) to directly select a channel or enter a number
via the menu.
EPG / ELECTRONIC PROGRAMME GUIDE Press this button
to show the current and upcoming programmes for each
channel. A 7-day preview is available as well.
EXIT: Press this button to exit the menu without saving
any changes.
MUTE: Press this button to mute all audio outputs of the
receiver. Press the button again to restore audio playback.
For Personal Video Recorder function – via USB
Time-shifted TV playback via USB memory
RECALL: Press this button to return to the previous
channel.
For Personal Video Recorder function – via USB
For Personal Video Recorder function – via USB
For Personal Video Recorder function – via USB
For Personal Video Recorder function – via USB
Selection of input signal / source
Recording directory
OK / ENTER: Press this button to save your selection or
menu settings.
Press this button to open the channel list
5