Notification Tones / Warning Tones; Troubleshooting - Ten-Haaft Premium OYSTER 65 Instructions For Use Manual

4. SERVICE

4.3 Notification tones / warning tones

Your Command Unit is provided with a sound generator to inform you of situations requiring your attention.
4.3.1 Road safety tones
A short tone sounds if you switch on the ignition with the antenna unfolded. This alerts you that the antenna
is still open and still needs some time to retract completely.
A continuous warning tone sounds if the antenna cannot fully retract while the ignition is on.
4.3.2 On-board voltage tones
If a short triple tone sounds in reception mode, you should check the charge state of the on-board battery. The
tone is repeated every minute of the on-board voltage is low. If the on-board voltage drops further, the tone will
sound every 15 seconds.
If a triple tone sounds when switching on the system, the antenna cannot unfold because the on-board voltage
is too low.
46
4. SERVICE

4.4 Troubleshooting

Stop function
It is essential that the antenna motion can be stopped at any time. A satellite search can be stopped or inter-
rupted by pressing the SAT button on the control panel, the Stop button on the Oyster® TV set's remote control
or the Power button on the Command Unit. After either of these buttons has been pressed, the system will no
longer accept any control commands.
Resetting the stop function
To cancel the stop function, press the Start button on the Oyster® TV set's remote control of a Premium system,
the SAT button on the control panel of a Vision system or the Power button on the Command Unit to send a new
motion command.
Fault description Remedial action
No satellite was found during Do you have a clear view to the South?
search. Are you inside the footprint of the satellite being searched?
Does your position require the LNB's SKEW angle to be adjusted?
The antenna does not retract or Is the motion obstructed by obstacles?
unfold properly. Is the supply voltage too low (weak battery)?
The antenna does not react Is the fuse OK?
after activation or does not Are all cables properly connected?
respond to commands.
Signal tone of the Command If the system receives a command to retract the antenna via the line
connected to terminal 15 / D+ (it is mandatory that this line is correctly
Unit
connected), but does not send a feedback to the Command Unit, a signal
tone will sound. Check whether the antenna has been retracted.
47