Table Of Contents - Ten-Haaft Premium OYSTER 65 Instructions For Use Manual
Hide thumbs
Also See for Premium OYSTER 65:
- Instructions for use manual (11 pages) ,
- Mounting instruction (24 pages) ,
- Mounting instruction (28 pages)
Table of Contents
Advertisement
CONTENTS
1. Control elements
1.1 Getting started / switching the system on and off
TV"
®
Be sure to observe the operating manual and installation instructions provided.
2
1. CONTROL ELEMENTS
1.1 Getting started / switching the system on and off
3
The only control elements of the fully automatic satellite system "Oyster® TV" Premium are the receiver integrat-
4
ed in the "Oyster® TV" Premium system and the remote control. The remote control buttons are only operational
5
when the "Oyster® TV" Premium system is switched on and the initialisation has been completed. Your system
8
can also be operated via the ten Haaft® app (see page 16, point 2.3, "ten Haaft® app").
10
SWITCHING THE SYSTEM ON / OFF
The system is switched into standby mode or completely off at the switch on the underside of the "Oyster® TV"
Premium system (see page 8, element 12 or page 10, element 10). Operation is started by pressing the POWER
14
button on the remote control.
15
16
Caution!
When switching on the "Oyster® TV" Premium system, the antenna will start the automatic satellite search. The
receiver integrated in the Oyster® TV" Premium system needs up to one minute to initialise after being switched
19
on. The antenna then folds up and starts the automatic satellite search.
20
Note: Unless specified otherwise, all information refers to the buttons of the remote control.
24
27
Caution!
32
When switching on the "Oyster® TV" Premium with integrated receiver, the antenna will unfold and start the
32
automatic satellite search.
37
1. Operate the switch on the side or underside of the device. The standby LED on the front illuminates red.
41
2. Press the POWER button on the remote control. The standby LED will illuminate blue.
SWITCHING THE DEVICE OFF
42
To switch the device into standby mode, press POWER. The standby LED will illuminate red. If you will not be
43
using the TV set for an extended period, you can turn it off at the switch on the side or underside. Note that the
46
system may first retract and then unfold to perform a satellite search when you switch it back on.
47
48
CONTROL PRIORITY OF AN "OYSTER® TV" SET USED IN A TWIN SYSTEM
If you have decided for a TWIN system with two "Oyster® TV" sets, the system can be controlled via the PRIMARY
"Oyster® TV" set only. In most cases, this will be the TV set in the living compartment of your recreational vehicle.
The secondary TV set cannot transfer any control commands to the antenna controller. Secondary TV sets are
usually located in the sleeping compartment.
You can also use your mobile device or tablet (IOS or Android) in combination with the ten Haaft® app on it at
any time to control and operate your system. See section 2.3 / page 16 in these instructions.
When controlling your Oyster® system via the app, the app's commands take priority. This means that you can
retract or unfold the antenna or change to another satellite even when the primary TV set is turned off; the app
can operate the antenna even if the first TV set is switched off.
3
Advertisement
Table of Contents
