Powering Down Your System Unit; Installing The 7002 Cable - IBM 5075 Setting Up

Figure 2. Planning for redundant link with two expansion units

Powering down your system unit

You must power down your system unit before you install your 5075.
__ 1. If you have logical partitions on your system unit, refer to the AS/400
__ 2. Ensure that all jobs are complete.
__ 3. When all jobs are complete, type pwrdwnsys *immed on an AS/400 command
__ 4. After your system unit has completely powered down, power off all PCs
__ 5. Unplug any power cords, such as for printers, expansion units, and display
__ 6. Unplug the power cord for your system unit from the electrical outlet.
__ 7. Did you receive a 7002 internal flex cable with your 5075?
__ 8. Go to "Installing the 7002 cable".

Installing the 7002 cable

If your 5075 came with the 7002 internal flex cable, you need to install it into your
AS/400 270 before you can set up your 5075. To install the 7002 cable follow these
steps:
__ 1. Remove the right side cover (view from back):
Information Center to find instructions on powering down a system with
partitions.
line and press the Enter key.
and devices, such as printers and display stations, that are connected to it.
stations, that are connected to your system unit.
Yes No
↓
Go to "Chapter 2. Installing your 5075 directly to your system unit"
on page 7 or "Chapter 3. Connecting your 5075 to another
expansion unit" on page 9.
__ a. Loosen the screws.
__ b. Slide the cover from front to back until it stops.
__ c. Pull the cover out.
Chapter 1. Preparing to set up your 5075 Expansion Unit
3