Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TDI TURBOTWIN T100-MS
Summary of Contents for TDI TURBOTWIN T100-MS
- Page 1 Publication: T1-795 Issued: August 1, 2008 INSTALLATION AND OPERATING MANUAL MODEL: T100-MS Gas Turbine Engine URBO Air Starter From Tech Development AN08-481 6800 Poe Ave. •Dayton OH 45414 Tel: (937) 898-9600 •Fax: (937) 898-8431 Website: www.tdi-turbotwin.com...
-
Page 2: Table Of Contents
TDI T URBO WIN™ TECH DEVELOPMENT FROM TABLE OFCONTENTS SECTION SUBJECT PAGE GENERAL INFORMATION ……………………….2 DESCRIPTION & NEW FEATURES…………….. 2 BASIC OPERATION………………………………..2 PRODUCT IDENTIFICATION……………………. 3 MOTOR PERFORMANCE & OUTPUT…………..3 INSTALLING THE MOTOR………………………. 4 ORIENTATION & LUBRICATION…………………5 SUPPLY & EXHAUST LINE INSTALLATION……6 MOTOR CONTROLS………………………………... -
Page 3: General Information
™ TECH DEVELOPMENT FROM 1.0 GENERAL INFORMATION NOTE THIS STARTER IS TO BE SERVICED ONLY BY AUTHORIZED TDI Instructions for installation, operation and maintenance TURBOTWIN™ DISTRIBUTORS, DEALERS, AND REPAIR of TDI T Model T100-MS Air Starter. STATIONS. DO NOT OPERATE THIS STARTER UNLESS IT IS URBO ™... -
Page 4: Product Identification
Direction of Rotation dynamic inlet pressures indicated performance charts). PART NUMBER IDENTIFICATION TABLE Starter output & operating speed vary TDI Part Number Solar Part Number considerably on DIFFERENT drive mediums T115-60034-MSL-1-90 1078362-100 (e.g. air vs. methane gas). T115-60G34-MSL-1-90 1078362-200... -
Page 5: Installing The Motor
& changes). section 2.1). If a vane-type starter motor is being replaced by a TDI turbine type starter, TDI recommends removal of in-line/mist type lubricators to minimize their inherent flow restriction to the starter and eliminate this maintenance item. -
Page 6: Orientation & Lubrication
TDI T URBO WIN™ TECH DEVELOPMENT FROM 2.1 PROPER INSTALLATION, ORIENTATION & OIL LEVEL MAINTNENACE OLAR P/N: 1078362-100 SOLAR P/N1078362-200 Motor/Starter Gearbox must be filled w/ (150ML) of Approved Oil Type** & Level Maintained OIL FILL PORT ½”-14 NPT Splash-lube... -
Page 7: Supply & Exhaust Line Installation
FROM All pipe threaded joints should be sealed with Loctite NOTE Pipe Thread Sealant (TDI P/N 9-94085) or equivalent, TDI recommends synthetic grade oil (turbine oil) is for leak tight joints prior to final assembly. Be sure to used in the starter gearbox sump. -
Page 8: Motor Controls
Alternately, pressure at commissioning (before running motors), TDI transducer may be installed at the pressure check port recommends a “blow-down” procedure to purge motor and electrical lines routed to a digital display at the supply lines of all hard debris that may otherwise operator's station. -
Page 9: Preventive Maintenance
Proper maintenance, qualified maintenance repair of oil levels can be easily maintained in your TDI TURBOTWIN starters & motors will assure the starter gearbox (See section 2.1) continued reliable and superior performance for many years. -
Page 10: Trouble Shooting Guide
TDI T URBO WIN™ TECH DEVELOPMENT FROM 5.0 TROUBLESHOOTING CHART TROUBLE PROBABLE CAUSE SOLUTION 1. Motor does not run; A. Valve not fully open. A. Repair or replace valve. small air flow from B. Nozzle blockage. B. Remove blockage or obstruction from nozzles. -
Page 11: Turbo Twin Warranty
This warranty constitutes the entire obligation of Tech Development relating to the sale and use of such product and TDI’s maximum liability is limited to the purchase price of such product at the date of purchase. In no event shall TDI be liable for incidental, indirect, consequential, or special damages of any nature arising from the sale or use of such engine starter product.
Need help?
Do you have a question about the TURBOTWIN T100-MS and is the answer not in the manual?
Questions and answers