Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TDI TurboTwin T100-V
Summary of Contents for TDI TurboTwin T100-V
- Page 1 Publication T1-321 Dated: November 15, 2013 INSTALLATION AND OPERATING MANUAL MODEL: T100-V Engine Air Starters URBO P/N: T112-60082-001 Tech Development From 6800 Poe Ave. Dayton OH 45414 Tel: (937) 898-9600 Fax: (937) 898-8431 Website: tdi-turbotwin.com...
-
Page 2: Table Of Contents
TDI T URBO WIN TECH DEVELOPMENT FROM TABLE OF CONTENTS SECTION SUBJECT PAGE General Information……………… ……... 1 Orientation of the Starter………………… 2 Installing the Starter……………………… 2 Starter Operation…………………………. 4 Starter Removal………………………….. 5 T100-V Warranty…………………………. 6 Troubleshooting Guide………………….. 7 LIST OF ILLUSTRATIONS... -
Page 3: General Information
Compressed air is used to power the T100-V through the affect T100-V starters. As with all TDI starters, no inlet port. The air is expanded through the first stage lubrication is required in the air supply. -
Page 4: Orientation Of The Starter
This model Confirm the part number T112-60082-001 of the starter weighs approximately 54 lbs. and is 16.8 inches in on the nameplate is the one recommended by TDI. length. The turbine housing diameter is 6.8 inches, which is common to all T100 T air starters. - Page 5 Loctite Pipe Only qualified personnel with corresponding Thread Sealant (TDI P/N 9-94085) or equivalent for leak professional training may perform pneumatic and tight joints prior to final assembly. Be sure to tighten all electrical connections to the T URBO WIN starter.
-
Page 6: Starter Operation
If the overhung section of the starter is not otherwise WARNING supported, TDI recommends that the exhaust piping be Do not operate the TDI T starter with air URBO supported with a suitable bracket(s). -
Page 7: Starter Removal
TDI T URBO WIN TECH DEVELOPMENT FROM Consult your TDI distributor if you have exhaust CAUTION plumbing that creates back pressure and reduces starter Do not engage the starter while the engine is performance. running. Follow the engine manufacturer’s instructions for starting The drive air pressure is the primary starter control the engine. -
Page 8: T100-V Warranty
This warranty constitutes the entire obligation of Tech Development relating to the sale and use of such product, and TDI’s maximum liability is limited to the purchase price of such product at the date of purchase. In no event shall TDI be liable for incidental, indirect, consequential, or special damages of any nature arising from the sale or use of such engine starter product. -
Page 9: Troubleshooting Guide
TDI T URBO WIN TECH DEVELOPMENT FROM 7.0 OPERATOR’S TROUBLESHOOTING GUIDE TROUBLE PROBABLE CAUSE SOLUTION 1. Air always flows through A. Relay valve improperly A. Check typical installation exhaust installed. diagram and correct. B. Relay valve not sealing B. Check for damaged sealing properly. -
Page 10: T100-V Envelope Drawing
TDI T URBO WIN TECH DEVELOPMENT FROM Figure 2. T100-V Envelope Drawing for P/N: T112-60082-001 Page 8 Publication T1-321 Issued November 15, 2013... -
Page 11: T100-V Installation Diagram
TDI T URBO WIN TECH DEVELOPMENT FROM Figure 3. T100-V Installation Diagram for P/N: T112-60082-001 Publication T1-321 Page 9 Issued November 15, 2013... -
Page 12: Performance Curves (Air)
TDI T URBO WIN TECH DEVELOPMENT FROM Page 10 Publication T1-321 Issued November 15, 2013...
Need help?
Do you have a question about the TurboTwin T100-V and is the answer not in the manual?
Questions and answers