Haier HWM180-M1990DD Owner's Manual page 16

Remove the power plug before carrying out any cleaning or maintenance.
Clean the lint filter(s) and detergent box after each wash, otherwise it may
influence you using the machine.
Clean the detergent box and set it on the
control panel seat.
1.The method of dismantle: Push it up aslant
and gently.
2.The method of clean: Use a brush and duster
cloth to clean it, then flush it with water.
3.The method of install : Install it upwards and
aslant and push it in.
Remove
The lint filter must be used during washing.
It must be cleaned in time after each using.
The mehods of dismantle and install lint filter as follows:
1.Push down the spring piece of the top lint filter to
make the claws out of the filter cover, and then pull
out the lint filter to get it down.(figure 1)
2.Pull the back of the lint filter, and then you can get
down it off the front cover of the lint filter.(figure 2)
3.Sweep the lint in the lint filter.
4.Put the back of the lint filter into the front cover.
5.Put the lint filter into filter cover, and make it tight.
6.Make sure the lint filter well installed, or it can
influence your use.
The back cover of the lint filter
Up
Install
Dismantle
Down
Figure 1
14
Up
Dismantle
Install
Down
The front cover of the lint filter
Figure 2