Electric Safety - MTX СМ120 User Manual

ATTENTION!
Non-compliance of safety requirements is life-threatening!
Voltage and frequency of current in the connected mains should correspond to the value specifi ed
on the name plate or in the operation manual for the product.
The productivity of the real machine can vary depending on fl uctuations of voltage in the local
power supply mains. Use of an extension cable can also aff ect machine productivity.
• The connecting safety socket should be designed for a current intensity of 10 A.
• For connection of the concrete mixer use a wire with a cross section of not less than 1.5 mm2.
• Before turning on of the machine it is necessary to check the power cable for damages or traces
of wearing.
• Never use the damaged cables and extension pieces.
• Protect the cable and extension piece from heat, avoid its contact with lubricants and also with
sharp objects and moving parts.
• Do not pull by the cable when moving the concrete mixer. Carry out all movements of the
concrete mixer with the disconnected cable.
• Observe the production environment. Do not use the concrete mixer during rain, in wet rooms.
Keep the working site dry, provide good lighting. Do not leave the concrete mixer in the open air
for the night. If water contacts the electric drive of the concrete mixer, there is an increased risk
of electric shock.
• When laying the power cable, watch that it is not been squeezed or bent and the plug connection
is not wet.
• Use only stationary electric connections according to the Electric installation code.
• The AP50B2MT automatic circuit breaker must be installed in an electric board and the power
supply of the concrete mixer should be carried out only through this switch.
• The mixer is provided with the protection against electric shock of class II. The class II will be kept,
if at repair original spare parts are used, and distances are not changed.
CONCRETE MIXER

ELECTRIC SAFETY

33