Waterway HANDHELD JET Installation

HANDHELD JET INSTALLATION

Handheld Jet Body

To install the handheld jet, unscrew an existing Waterway poly jet (turn counterclockwise). The

existing jet may require a jet wrench for removal, available from your local spa retailer.

If the existing jet features a metal trim ring, it may have to be removed to allow removal of the

existing jet and installation of the new jet. This ring can be removed by prying around its edge

with a flat-head screwdriver. Use care to avoid prying the plastic jet body from the spa wall as

this will cause the spa to leak.

Using your finger tips, screw in the handheld jets internal, until it locks in place. The handheld jet

may be cleaned using any mild soap. DO NOT use abrasive or solvents for they can damage the

plastic parts.

For product registration visit: www.waterwayplastics.com.

For Warranty questions or claims please contact point of purchase.

Designed,

Engineered &

Manufactured

in the USA.

2200 East Sturgis Road, Oxnard CA 93030 • Phone 805.981.0262 • Fax 805.981.9403

Existing Poly

Jet Body

Tip: Once installed, rotate the jet's trim ring to adjust

the water ow of the jet to your speci cations

www.waterwayplastics.com • waterway@waterwayplastics.com

Spa

810-0007.0618

Table of Contents

Do you have a question about the HANDHELD JET and is the answer not in the manual?

Page 1 Using your finger tips, screw in the handheld jets internal, until it locks in place. The handheld jet may be cleaned using any mild soap. DO NOT use abrasive or solvents for they can damage the plastic parts.
Page 2 Using your finger tips, screw in the handheld jets internal, until it locks in place. The handheld jet may be cleaned using any mild soap. DO NOT use abrasive or solvents for they can damage the plastic parts.