Toyota Sienna Quick Reference Manual page 40

TOYOTA SAFETY SENSE
PCS PEDESTRIAN DETECTION
Under certain conditions, the PCS system included with the TSS-P package may
also help to detect a pedestrian in front of your vehicle using the in-vehicle camera
and millimeter-wave radar. The in-vehicle camera of PCS detects a potential
pedestrian based on size, profile, and motion of the detected pedestrian. However,
a pedestrian may not be detected depending on the conditions, including the
surrounding brightness and the motion, posture, size, and angle of the potential
detected pedestrian, preventing the system from operating or engaging.
As part of the Pre-Collision System, this function is also designed to first provide an
alert and then automatic braking if needed.
Refer to the Toyota Owner's Manual for additional limitations and information.
CHANGING PCS ALERT TIMING
(1) Press " " switches and select
(2) Press " or
and then press "
(3) Select "Sensitivity" and then press "
response to the PCS alert timing changes as shown above. You can press "
go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition On. The
system can be disabled/enabled and the alert timing of the system can be changed.
(Alert timing only, brake operation remains the same).
Monocular camera sensor
" switches and select the
". The setting screen is displayed.
™
Middle
Far
(default)
from the MID.
setting function from the MID
." Each time "
38
Millimeter
wave radar
Near
" is pressed, the
" to