Advertisement
RPK5-GM4102
Sub-Dash Preparation (cont.)
Note: Some radios will require extra
depth during installation. If you encounter
this issue please follow the next two steps
to modify the dash for extra clearance.
***Warning: Check for factory wiring
harnesses around (including behind)
this area before cutting. Use caution
not to cut any of this wiring!***
Kit Assembly Instructions
Single DIN Mount Applications
1. Snap and lock each of the side brackets onto the pocket. (FIG 1)
2. Insert ISO mountable radio between the side mount brackets and
loosely attach to the sides of the radio using the screws provided
with radio when possible or the hardware included with kit.
3. Slide radio component forward or backward for desired look and
tighten screws.
4. Attach a rear support bracket to the rear of the new radio and
adjust as necessary to attach to the rear support stud located on
the back of the pocket using the small phillips screw supplied with
kit (optional).
5. Insert kit and radio into dash. Line up with the factory mounting
point. Secure to the dash using the factory 7mm bolts.
FIG 1
Installation of the PAC HVAC control panel
Vehicles equipped with Non-MyLink radios
1. Connect the RPK5-GM4101-KIT-HAR to the vehicles white 20-pin connector that was originally connected to the factory HVAC control panel.
2. Connect the 8-pin Black Micro-fit Molex connector to the circuit board mounted to the back side of the PAC HVAC control module.
3. Tape up or remove the loose Orange / Black and Pink / Black wires as they are only needed for applications where the vehicle was factory
equipped with the touchscreen MyLink radio. (see next page)
4. Fit the PAC HVAC control panel into the vehicle opening and secure at the bottom using the factory mounting hardware.
5. Assemble the remaining pieces of the dash.
Pacific Accessory Corporation
4. Locate the factory radio module mounting
hole towards the back of the dash opening.
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Email - support@pac-audio.com - Phone: 727-592-5991
Complete Radio Replacement Kit with Integrated Climate
Control Retention for 2010-2015 Chevrolet Camaro
Double DIN Mount Applications
1. Remove the Shaded tab from the back edge of each left and right
mounting bracket (right side not shown). (FIG 2)
2. Attach the left and right side brackets to an ISO mountable radio
using screws provided with radio when possible or hardware in-
cluded with kit. (FIG 3)
3. Insert kit and radio into dash. Line up with the factory mounting
point. Secure to the dash using the factory 7mm bolts.
FIG 2
PAC-audio.com
5. Cut and remove the portion that extends
towards the front dash opening.
FIG 3
Rev: R6
Date: 010419
UNLESS OTHERWIS
DIMENSIONS ARE
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
NA
DRAWN
CHK'D
APPV'D
MFG
Q.A
Page 7
Advertisement
