Advertisement
RPK5-GM4102
Removing the factory radio from the vehicle
1.1 - Apply the parking brake. Move the transmission shift
assembly to the most rearward position possible. Use a flat
bladed plastic trim tool to release the retainer tabs securing
the front floor console front cover to the console assembly.
Lift the cover (1) up and towards the rear, making sure that
the accessory power receptacle and the electronic traction
control switch clears the transmission shift assembly. It may
be necessary to pop these items loose from the underside to
achieve clearance. Disconnect the harnesses.
1.3 - Remove the 4 x 7mm bolts (1) securing the radio
(2) into the dash. Slide the radio (2) to the rear and
disconnect all electrical connections.
Pacific Accessory Corporation
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Email - support@pac-audio.com - Phone: 727-592-5991
Complete Radio Replacement Kit with Integrated Climate
Control Retention for 2010-2015 Chevrolet Camaro
1.2 - Remove the 2 x 7mm bolts (1) securing the radio
control assembly (2) into the dash. Then use a flat-
bladed plastic trim tool to release the retainer clips
securing the radio control assembly (2) to the instrument
panel. Disconnect the electrical connections.
You can now set the factory radio aside as it will not
Proceed to the next section to transfer the retention
clips from the factory radio control assembly to the
PAC HVAC control assembly.
PAC-audio.com
be needed any longer.
Rev: R6
Date: 010419
Page 2
Advertisement
