Advertisement
RPK5-GM4102
Dash Panel Assembly
To secure the top of the PAC HVAC control assembly into the dash, remove two of the retention clips located on the back side at the top of the
factory radio control assembly, and reuse them on the PAC HVAC control assembly.
2.1 - Using a flat bladed pry tool, carefully remove two of the
retention clips off of the black plastic backing of the factory radio
control assembly.
Knob Inserts
For vehicles without heated seats: Remove the center cap called "Blank Left" and snap that into the climate control knob labeled Left. The insert
is keyed, so it will only fit in one orientation. Remove the center cap called "Blank Right" and snap it into the climate control knob labeled Right.
For vehicles equipped with heated seats: Carefully open the package labeled "Heated Seat Left". There will be a center cap and 2 small, clear
plastic, light pipes. They are keyed, so they will only fit in one specific hole each.
1. From the front of the control knob, insert the light pipes (non-keyed side first) into the small rectangular openings.
2. The left light pipe (A) has a key tab on the narrow side. Insert this light pipe with the key facing down.
3. The right light pipe (B) has the key tab on the wide side. Insert this light pipe with the key facing to the right.
(A)
key tab
Pacific Accessory Corporation
(B)
key tab
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Email - support@pac-audio.com - Phone: 727-592-5991
Complete Radio Replacement Kit with Integrated Climate
Control Retention for 2010-2015 Chevrolet Camaro
2.2 - Slide the retention clips (removed during the previous
step) onto the two black posts at the top of the PAC HVAC
PAC-audio.com
control assembly.
Close-up of light pipes installed
Rev: R6
Date: 010419
Page 3
Advertisement
