Table of Contents
Advertisement
EVAPORATOR COIL REMOVAL
Disconnect the power
CAUTION:
supply before servicing
the cabinet.
A. Raise up the counter top.
B. Remove screws along the back wall
of the sub top.
C. Remove the high air intake baffle
located on the righthand side of the
sub top.
D. Remove the cabinet lids and lid rails.
E. Remove the screws that hold the
light channel to the sub top.
F.
Pull the defrost termination bulb out
of the evaporator coil bulb well. Lift
the sub top up and out of the cabinet.
1. Defrost Termination & High Limit Control
2. Defrost Termination Bulb Well
5 5
5 5
6 6
6 6
7 7
7 7
Reseal bulb well and coil cover with permagum
NOTE:
as shown.
8. Coil Cover
9. V Baffle Heater
36
1 1
1 1
3. Defrost Heater Receptacle
4. Sub Top
G. Lift the insulation up and out of the cabinet. Do not
break. This will expose the coil housing cover. This
cover is attached by three screws, one on each
end and one at the rear on the top.
5. Upper Coil Insulation
6. V Baffle Insulation
7. V Baffle Front
4 4
4 4
2 2
2 2
8 8
8 8
9 9
9 9
MAINTENANCE & REPAIR
3 3
3 3
Advertisement
Table of Contents
