Front Glass Heater Replacement - Carrier CMCT Series Service & Installation Manual

FRONT GLASS HEATER REPLACEMENT

Disconnect the power supply before
CAUTION:
servicing the cabinet.
Photograph shows the electrical connection between
the cabinet and the front glass heater.
34
REMOVAL OF FRONT GLASS HEATER
AND/OR END TRACK:
1. Remove glass lids.
2. Remove side arm trim (A) at both sides per detail
'A'.
3. Remove three (3) screws in vertical trim post (F)
and pull vertical trim post forward. Typical at both
ends.
4. Remove three (3) screws in end track (B). Pull
track forward and lift up. Typical both ends. (Not
necessary for glass removal.)
5. Remove two (2) screws in the front of center
track (G) and swing center track from dotted line
position to solid line position.
6. Remove two (2) screws (one each end) on glass
rail (C) and lift glass rail straight up.
7. Pull top of front glass (D) forward and lift glass
and heater (E) up.
8. To remove end track only, execute the first four
steps. To remove front glass heater, execute the
first seven steps, omitting step number 4.
NOTE: Pay close attention to the way the heater
wire is arranged on the front glass when replacing.
MAINTENANCE & REPAIR