Table of Contents
Advertisement
Therm-App MD User Manual
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------
PRODUCT USAGE NOTICES
Attachment to your Mobile Device
To avoid damage to your Product and mobile device, attachment of the Product to your mobile device should be done with care, securing
the locking knob with your fingers only. Do not use any external tools as too much pressure may mark or damage your mobile device.
Calibration
The Product makes use of specific calibration data, which was prepared for it in the factory. It is possible that during prolonged field usage
of the Product a deterioration of image will be noticed. In such cases, we recommend that you send in the device for re-calibration at the
factory. Please contact our support team for further instructions.
Accuracy
For most accurate temperature measurement results, we recommend that you wait 8-10 minutes after you have started the Product before
.
measuring a temperature
Disposal of electronic waste
As with most electronic products, this equipment must be disposed of in an environmentally friendly way, and in accordance with existing
regulations for electronic waste.
Documentation updates
Our manuals are updated from time to time, and we also issue product-critical notifications occasionally.
17.
PRODUCT SAFETY INFORMATION
WARNING
Applicability: Class B Digital Product
This Product has been tested and found to comply with the limits for a Class B digital Product, pursuant to Part 15 of the FCC Rules of the
USA. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This Product
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If the Product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, you are encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the Product and receiver .
Connect the Product into an outlet on a circuit different from that to which the receiver is connected.
Consult the authorized reseller or an experienced radio/TV technician for help.
WARNING
Do not drop the Product or apply pressure on the IR lens as it may break. If the IR lens breaks, do not touch the broken pieces; the pieces
can cause injury.
WARNING
Be careful when you touch the Product. Some parts of the Product can be sharp and could cause injury.
WARNING
Do not point the infrared detector (with or without the lens and lens cover) at intensive energy sources, for example products that emit
laser radiation, or the sun. This can have unwanted effects on the performance of the Product. It can also cause damage to the detector.
WARNING
Do not use the Product in a temperature environment higher than +50 degrees Celsius (+122 degrees Fahrenheit), unless specified
otherwise in user documentation or technical data. High temperatures can cause damage to the detector.
WARNING
The Product is not sealed. Avoid exposure of the Product to water, rain or dust.
WARNING
Do not apply solvents or similar liquids to the detector or lens, as this can cause damage.
------------------------------------------------------------------------------------------------------------------------------------------------------------
Page 24 of
25
Advertisement
Table of Contents
