Fein ASCM12 Instruction Manual page 20

OBJ_BUCH-0000000367-001.book Page 20 Thursday, February 14, 2019 2:50 PM
en
20
Adjusting the gear setting
(ASCM12 (**)) (figure 13).
Always slide the gear selector to the stop.
Otherwise, the machine can become dam-
aged.
You can adjust 4 gear settings.
Set the lowest gear setting to work at low
speed with high torque. This gear setting is
suitable for screwing in large screw diameters.
Set the highest gear setting to work at high
speed with low torque. This gear setting is
suitable for drilling with small drill bit diame-
ters.
The material-dependent gear setting can be
determined by practical testing.
Adjust the rotation direction only when
the machine is at a complete stop.
Switching on and off (figure 14).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
In case of overload, the machine switches off.
Thermal overload of the power tool is indi-
cated through flashing of the LED in the han-
dle.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Fig. 13
Gear selector
Fig. 14
1.
2.
On/Off switch