Gear Selection - Polaris PRO HD 4500 Manual

GEAR SELECTION

WARNING
Attempting to shift the winch while the rope is under
tension is dangerous and can result in injuries or
death. Make sure the winch rope is not in tension
before shifting the winch between gears.
Your winch is equipped with three different gear
settings. High, Neutral and Low. When in neutral the
"N" marking will show thru the cutout window on the
shift knob. See photo below.
Instr 9927471 Rev 01 2016-11
The high gear setting is meant for rapid recovery
mode only and should not be used while the rope is
under load. To shift into high gear, rotate the gear
shifting knob clockwise until the "H" marking shows
thru the cutout window on the shift knob. See photo
below.
High gear is for rapid recovery of the winch rope
only. It is not intended for pulling and will reduce the
life of the winch if used under load.
To shift into low, rotate the gear shifting knob counter-
clockwise until the "L" marking shows thru the cutout
window on the shift knob. See photo below.
Page 9 of 13
NOTE