Winch Installation - Polaris PRO HD 4500 Manual

CONTACTOR INSTALLATION
a
1. Install contactor to center frame member under
hood using two screws
until snug. Do not overtighten.
2. Connect short (250mm) red
to the vehicle bus bar as shown. Connect the other
ends of cables to their respective colored posts on
contactor and torque to specification. Slide the
cable covers on as shown.
TORQUE
4ft. lbs. (5.4 Nm)

WINCH INSTALLATION

1. Install winch mounting bracket
A
bumper using four screws
2^
washers on lower side and two self-tapping
2&
screws at the top as shown. Tighten bolts and
nuts to specification, but tighten self-tapping
screws just until snug.
1(
as shown. Tighten just
i o
and black cables
f
onto the front
k 2@
, nuts , and
Instr 9927471 Rev 01 2016-11
TORQUE
20ft. lbs. (27.1 Nm)
2. Install new grill screen
retained two screws
3. Install auto stop fairlead
f
bracket using two screws
torque to specification.
TORQUE
16ft. lbs. (21.7 Nm)
Page 5 of 13
d A
on front bumper
D
.
s
to winch mounting
2! 2@
and nuts and
using