YORKVILLE YS1089 Owner's Manual page 4

The YSM5, YSM6 and YSM8 feature 1-inch black-silk diaphragm neodymium dome
tweeters. These tweeters use specially designed waveguide bevelled edge housings.
The waveguide bevelled edges perfectly couple the tweeter with the woofer, reducing
sonic anomalies normally created by their proximity. The leading-edge fibre-composite
cone woofers have also been designed to perform with sonic excellence, providing a
wide dynamic range at all levels. Transparent bi-amplification is specifically optimised
for each driver. This guarantees perfect performance and eliminates the phase irregu-
larities between tweeter and woofer that are usually associated with passive crossover
networks.
1. Mains Voltage Select Switch, Cord and Fuse Replacement
Before plugging the power cord in the back of the YSM5, YSM6 or YSM8 set the
Voltage Switch to the required voltage, either 110-120 VAC (North America) or 220-
240 VAC (Europe and Australia).
If the unit does not power up, check...
2
Mains Voltage
Select Switch
110-120
VAC
NOTE: If the fuse needs replacing, disconnect the power cord from the back of the unit; using a
small flat head screw driver, pry out the plastic fuse holder located just beside the power recep-
tacle. Refer to replacement values printed at the back of the unit, near the Serial Number.
i. Power cord is connected.
ii. Power source is turned on.
iii. Fuse is blown, if replaced and it still blows then there is permanent fault inside
the unit and should be returned to a Yorkville dealer.
YSM5, YSM6 and YSM8
Powered Studio Monitors
Welcome to the next generation of Yorkville
Sound Powered Studio Monitors. Building
upon our technical knowledge and experience
we have developed better sounding monitors
which are easier to use in virtually any envi-
ronment. The Yorkville Sound monitors are at
home in professional recording studios, home
studios and living rooms. We're confident that
the YSM5, YSM6 or YSM8 will help you cut to
the mix and create fantastic music!
220-240
VAC
YSM