Table of Contents
Advertisement
Preparing for surround sound
6 Use the TRIM %/ fi keys to select the appropriate center
speaker setting.
If you selected "LRG" as the front speakers setting,
1 CNTR NM L
2 CNTR LRG
3 CNTR OFF
If you selected "NM L" as the front speakers setting,
1 CNTR ON
:
2 CNTR OFF
:
7 Press the SET UP key again to accept the setting.
• The surround speaker indication " SURR" appears.
8 Use the TRIM %/ fi keys to select the appropriate surround
speaker setting.
If you selected "LRG" as the center speaker setting,
1 SURR NM L
2 SURR LRG
3 SURR OFF
If you selected other than "LRG" as the center speaker setting,
1 SURR ON
: Surround speaker setting mode to the
2 SURR OFF
: Surround speaker setting mode to the
• When the setting " SURR OFF" is selected, by pressing the SET
UP key in step 9 the procedure skips to step @ . But if " SW
OFF" is selected, press the SET UP key to skip to step 5 .
9 Press the SET UP key again to accept the setting.
• The back surround speaker setting indication " BS" appears.
0 Use the TRIM %/ fi keys to select appropriate surround back
speaker setting.
If you selected "LRG" as the surround speaker setting,
1 BS NM L
: Average size back surround speaker is
2 BS LRG
: Large back surround speaker is con-
3 BS OFF
: Back surround speaker setting mode to
DOLBY DEX
NEO:6
DSP
TS
MUTE
DOLBY PLII
DTS -ES AAC
DISCRETE
MATRIX 6.1
ACTIVE EQ.
If you selected "NM L" as the surround speaker setting,
1 BS NM L
: Back surround speaker setting mode
to the amplifier is ON.
2 BS OFF
: Back surround speaker setting mode
to the amplifier is OFF.
16
EN
: An average size center speaker is
connected to the amplifier.
: A large center speaker is connected
to the amplifier.
: Center speaker setting mode to the
amplifier is OFF.
Center speaker setting mode to the
receiver is ON.
Center speaker setting mode to the
receiver is OFF.
: Average size surround speakers are
connected to the amplifier.
: L ar g e s u r r o u n d s p e ak e r s ar e
connected to the amplifier.
: Surround speaker setting mode to
the amplifier is OFF.
amplifier is ON.
amplifier is OFF.
connected to the amplifier.
nected to the amplifier.
the amplifier is OFF.
DIGITAL
ST.
L
AUTO
LFE
LS S
! Press the SET UP key again to accept the setting.
• The subw oofer remix setting indication " REM IX" appears.
• If subw oofer is turned off, subw oofer re-mix setting is not visible.
DOLBY DEX
NEO:6
DOLBY PLII
DTS -ES AAC
DISCRETE
MATRIX 6.1
ACTIVE EQ.
@ Use the TRIM %/ fi keys to select the appropriate subw oofer
re-mix setting.
1 REM IX ON
2 REM IX OFF
When "REM IX ON" is selected, bass sound of other channel
w ill be added into Subw oofer or bass sound of Subw oofer
w ill be added into other channel to increase deep bass
performance.
# Press the SET UP key again to return to the
• The receiver enters the speaker volume level adjustment mode.
• In steps 5 and 6 , indications appear only for the selected
channels of the speakers that require adjusting.
5
Adjust the speaker volume level.
From your usual listening position, adjust the volume levels. The
volume levels from each speaker should be the same.
1 Press the SET UP key and then use the TRIM %/ fi keys to
select TEST TONE.
2 Press the SET UP key for the follow ing displays:
The selection of AUTO or M ANUAL is done by the TRIM %/ fi
keys.
1 AUTO
2 M ANUAL
3 Press the SET UP key again to begin TEST TONE.
Use the TRIM %/ fi keys to adjust the volume level of the test
tone output from the speaker channel to be adjusted.
For AUTO selection, the first test tone is heard from the front left
speaker for 3 seconds. The next test tone is heard from the
speakers in the follow ing sequence for 3 seconds each.
The channel indication blinks w hile the test tone is being output.
C
R
DOLBY DEX
NEO:6
SW
DOLBY PLII
DTS -ES AAC
BS
RS
DISCRETE
MATRIX 6.1
ACTIVE EQ.
• If you change the volume level settings for the speakers w hile
listening to music, the settings referred to on this page are also
changed.
• If the speaker setting selects are OFF, the speaker level settings
are reset.
For "M ANUAL" selection, press the FRONT, CENTER, REAR
or SW keys to select the speaker channel and then adjust the
volume level by pressing TRIM %/ fi keys.
DSP
TS
MUTE
DIGITAL
: Subw oofer re-mix setting mode to
the amplifier is ON.
: Subw oofer re-mix setting mode to
the amplifier is OFF.
L
C
R
SW
LS
DSP
TS
MUTE
DIGITAL
ST.
L
C
R
AUTO
LFE
SW
LS S BS RS
2
.
RS
BS
ST.
L
C
R
AUTO
LFE
SW
LS S BS RS
Advertisement
Table of Contents
