Start Display; Measure References; Fluorescence Intensity Reference (F256 Or F365) - FAG FLUO DX User Manual

Start Display

After the reset display or when returning from any other mode, the Start display is shown.
Key A: Measure the intensity of the Fluorescence or Phosphorescence signal.
Key B: Laboratory functions (Colorimetric measurements, Phosphorescence curve)
Key C: Special Functions (Delta E measurement)
Key D: Measure references for Intensity Measurements.

Measure References

References for Fluorescence with 256nm or 365nm and two Phosphorescence reference sets with
different timing settings can be measured.

Fluorescence Intensity Reference (F256 or F365)

Up to 4 references can be stored in the device. If a reference is available, the proper number is
displayed with brackets [ ]. Select the reference number you would like to measure.
Key A: Select the Filter. You can choose one of the physical filters R, G or B. You can also select the
black Filter K which is defined as R+G+B. Finally the A (Automatic filter selection) will automatically
select the filter with the highest Signal response on the very first reference measurement.
Key B: Switch the positioning LED on.
Key C: Delete previously stored reference values.
15.03.2020 5