Device Status Information; Positioning Led - FAG FLUO DX User Manual

Key C: Perform a Function test of the device.
Key D: Next screen

Device Status information

Whenever appropriate the device status information will be displayed on the right top corner:
USB is connected.
Data memory used, empty to full.
Battery empty, change Batteries.
Battery nearly empty. Change battery at the end of the measurement sequence.
Battery still ok.

Positioning LED

Whenever the device is in measurement mode you can use the positioning LED in front of the device
to find the measurement position on the invisible ink. Press and hold Key B. The positioning LED will
go off upon release of Key B or after 20 seconds.
Never ever look directly into the UV positioning LED as this might hurt your eyes. The device display
shows a proper warning.
In order to turn the positioning LED on, the following conditions have to be met;
•
Device is in the flat position.
•
Device is not in the measurement position but in parking position.
•
After 20 seconds on, the UV positioning LED turns off. In order to switch it on again release
and press Key B. Release Key B to switch the positioning LED off.
15.03.2020 4