Wireless Handset - McQuay MDS Series Service Manual

3.4.1 Wireless Handset G17
3
1. Transmission Source
2. Signal Transmission Indication

Blink to confirm that the last setting has been transmitted to the unit.
3. Temperature Setting

Temperature setting range is from 16° C to 30° C (optional setting 20° C to 30° C).
4. Personalize Setting

Press and hold for 3s, then

Set the desire setting, then leave the handset for 4s without pressing any key and it will save the setting
into the program.

Press once to activate the P1 setting, press again to cycle between P1 and P2.

Press any key to deactivate the personalize setting.
5. Automatic Air Swing (optional)

Press the SWING
at the desired direction.
6. Ionizer Function (For WM - G series only)

Press button to activate the negative ion function, which will refresh the indoor air effectively.
7. Sleep Mode Setting

This function is available under COOL, HEAT and AUTO mode.

When under cooling mode, the set temperature is increased by 0.5° C after 30 minutes, 1° C after an
hour, and 2° C after 2 hours.

When under heating mode, the set temperature is decreased by 1° C after 30 minutes, 2° C after an hour,
and 3° C after 2 hours.
8. Operating Mode

Press the MODE button to select the type of operating mode.

For cooling only unit, the available modes are: COOL, DRY and FAN.
9. Fan Speed Selection

Press the
Low

Stop pressing when the desired fan speed appears on the display screen.
22
will blink. Press again to cycle between
button to activate the automatic air swing function. Press again to stop the louver
button continuously will toggle the fan speed in the following order:
Med High Auto
and ..
Service Manual SM-MDS_(ii)