Bushnell WIRELESS Trophy Cam HD Instruction Manual page 41

• You will get the best results when the subject is within the ideal
flash range, no farther than 60' (19m) . Subjects may appear too
dark at greater distances.
• Please note that when the Capture Number parameter is set
higher than "1 Photo", or with very short Interval settings, some
images may appear darker than others due to the quick response
and rapid retriggering of the camera, allowing less time for the
flash to fully recharge before firing again.
• Make sure "LED Control" in the setup menu is set to "High" to
ensure maximum output. You can also try setting "NV Shutter" in
the menu to "Low" (slower shutter speed=brighter images, with
tradeoff of increased blur if subject moves rapidly).
• The ARD (anti-reflective device) shield can be removed to
maximize flash output. See page 34 for more details.
2. Daytime photos or videos appear too dark
• Make sure that the camera is not aimed at the sun or other light
sources during the day, as this may cause the auto exposure to
produce darker results.
3. Night photos or videos appear too bright
• If the subject is close to the camera (less than10ft/3m), change the
LED Control parameter in the Setup Menu to "Medium" or "Low".
4. Daytime photos or videos appear too bright
• Make sure that the camera is not aimed at the sun or other light
sources during the day.
5. Photos with streaked subject
• In some cases with low lighting conditions and fast moving
subjects, the 5MP or 8MP resolution settings may not perform as
well as the 3MP setting.
• If you have multiple images where fast moving subjects produce
streaks on the photo, try the 3MP setting instead.
• Set "NV Shutter" to "High" to minimize motion blur.
6. Red, green or blue color cast
• Under certain lighting conditions, the sensor can become
confused resulting in poor color images.
• If this is seen on a consistent basis, then the sensor may need
servicing. Please contact Bushnell customer service.
41