Converting From Blower To Vacuum; Assembling The Blower - Toro Ultra 51619 Operator's Manual

Setup
Register your product at www.Toro.com so that Toro can notify
you in the case of a safety or warranty product recall.
1. Blower tube
2. Bottom inlet cover

Assembling the Blower

Important:
The motor should not run unless the bottom
inlet cover is locked in place.
Note:
If the motor runs without the bottom inlet cover in place,
do not use the appliance. Return it to an Authorized Service
Dealer.
Install the blower tube and bottom inlet cover.
Figure 2
3. Upper vacuum tube
4. Lower vacuum tube
Converting from Blower to
Vacuum
WARNING
The impeller rotates for a few seconds after you turn
off the appliance and can cut or injure fingers.
Do not remove the bottom inlet cover when the motor
is running or when the appliance is plugged into a
power outlet.
g224170
1. Remove the bottom inlet cover and the blower tube.
2. Install the vacuum tube and bag.
Important:
vacuum tube is locked in place.
Note:
If the motor runs without the vacuum tube in place,
do not use the appliance. Return it to an Authorized Service
Dealer.
g227713
3. Adjust the bag strap as needed for comfortable operation.
3
The motor should not run unless the
g227714
g227715