Maintenance; Warranty - Hoshizaki KM-115B Instruction Manual

[1] Remove the water from the potable water supply line:
1) Remove the louver if it has not already been removed.
2) Move the control switch on the control box to the "OFF" position. See
Fig. 5.
3) Wait 3 minutes.
4) Close the potable water supply line stop valve. See Fig. 4.
5) Remove the inlet hose.
[2] Drain the potable water tank:
1) Move the control switch to the "SERVICE" position and the service
switch to the "DRAIN" position.
2) After 2 minutes, move the control switch to the "OFF" position.
3) Open the door. Remove all ice from the storage bin and clean the
storage bin.
4) Close the door.
5) Replace the louver in its correct position.
6) Turn off the power supply at the breaker box.
III. MAINTENANCE
1. CLEANING
WARNING
1. Before carrying out any cleaning or maintenance operations,
unplug the icemaker from the electrical supply network.
2. Ask a trained service person to check and clean the condenser
at least once a year.
3. This appliance must not be cleaned by use of a water jet.
4. Do not use any alcohol for cleaning/sanitisation of the icemaker.
It may cause cracks on the plastic parts.
5. To prevent possible damage, do not clean the plastic parts with
water above 40°C or in a dishwasher.
[1] Exterior
Wipe the exterior at least once per week with a clean, soft cloth. Use a
damp cloth containing a neutral cleaner to wipe off grease or dirt.
[2] Scoop and Bin Door Grip Cleaning/Sanitisation (Daily)
1) Either mix 3 litres of water with 11 ml of 5.25% sodium hypochlorite
solution in a suitable container, or the recommended Hoshizaki
sanitiser as directed.
2) Soak the scoop in the solution for more than 3 minutes. Rinse
thoroughly, and shake to remove surplus liquid.
Note: Using a cloth to dry may re-contaminate.
3) Use a neutral cleaner to wash the bin door grip. Rinse thoroughly.
4) Soak a clean cloth with the sanitising solution, and wipe the grip. Use
fresh water and a clean cloth to rinse/dry.
[3] Storage Bin Interior Cleaning/Sanitisation (Weekly)
1) Open the storage bin door, and remove all ice.
2) Wash the bin liner with a neutral non-abrasive cleaner. Rinse
thoroughly.
3) Soak a clean cloth with the neutral cleaner, and wipe the door inner
surface. Wipe off the cleaner with a clean damp cloth.
4) Either mix 3 litres of water with 11 ml of 5.25% sodium hypochlorite
solution in a suitable container or the recommended Hoshizaki
sanitiser as directed.
5) Soak a clean sponge or cloth with the solution, and wipe the bin liner
and bin door.
6) Rinse thoroughly with fresh water and a clean cloth to wipe off the
solution. Close the bin door.
Note: Some solutions may cause damage to the bin liner surfaces or
corrosion on the metal parts. Always rinse the sanitiser unless
directed otherwise by Hoshizaki guidelines.
[4] Air Filter
Plastic mesh air fi lters remove dirt or dust from the air, and keep the
condenser from getting clogged. If the fi lters get clogged, the icemaker's
performance will be reduced. Remove and clean the air fi lters at least
twice per month:
1) Tilt the louver forward, and remove the air fi lter.
2) Clean the air fi lter by using a vacuum cleaner. When severely clogged,
use warm water and a neutral cleaner to wash the air fi lter.
3) Rinse and dry the air fi lter thoroughly, and place it in position.
[5] Icemaking Water System
To keep the icemaker hygienic, periodic cleaning of the icemaking water
system is recommended. Always ask a trained service person to clean
the water system.
Note: 1. The washing switch on the control box is intended for use by
service personnel only.
2. During normal icemaking operation, keep the washing switch
in the "ICE" position.
2. BEFORE CALLING A SERVICE AGENT
Do not damage the refrigerant circuit.
If the icemaker does not work properly or does not work at all, before
calling for service, check that:
* The power is supplied to the unit.
* The control switch is in the "ICE" position.
* The water is turned on.
* The air fi lter is clean.
For further assistance or advice, contact your local Hoshizaki service
agent.

3. WARRANTY

Hoshizaki warrants to the original owner/user that all Hoshizaki branded
products shall be free of defects in material and/or workmanship for the
duration of the "warranty period". The warranty shall be effective for
three years from the date of installation.
Hoshizaki's liability under the terms of the warranty are limited and
shall exclude routine servicing, cleaning, essential maintenance and/or
repairs occasioned by misuse and installations not in accordance with
Hoshizaki guidelines.
Warranty repairs should be completed by an approved Hoshizaki dealer
or service agency using genuine Hoshizaki components.
To obtain full details of your warranty and approved service agency,
please contact your dealer/supplier, or the nearest Hoshizaki Service
5
ENGLISH
WARNING