Installation - WilTec 50799 Operation Manual

Quad / motorbike jack lift
Hide thumbs Also See for 50799:
Table of Contents

Advertisement

Control/inspection
The device should be visually checked before every use to be able to exchange damaged, broken or
missing parts on time. The device needs to be checked immediately by a specialist, in case any un-
foreseen fault occurs. If one of the strap chains seems to be damaged, the device needs to be taken
out of order instantly until it has been repaired by a specialist. It is recommended to have the device
checked at least once a year by a specialist.

Installation

Mount the hydraulic cylinder to the mounting plate with screws, washers and nuts. Make sure
the discharge is not damaged during this process.
Place the upper end of the lifting cylinder into the lifting frame and fix it with the bolt.
Install the foot pedal to the hydraulic cylinder and fix it with an M8 x 30 screw.
Place the handle in the intake of the lifting frame and secure it with a bolt.
The locking bar needs to be locked into one of the positions when lifting weights. If this is not
the case, it can lead to damage of the jack lift or to serious injury.
Check whether all screws are tightened. Then make sure that the tip of the locking bar is be-
hind a notch of the frame.
Operating Instructions
Lifting Objects
Use the jack lift only on an even and solid underground.
To prevent the loaded object from slipping during the lifting process, centre the weight evenly.
Place the jack so that the lifting saddle is placed centrally under the object needing to be lifted.
Operate the foot pedal until the lifting saddle touches the object needing to be lifted. Fixate the
castor rollers. Before raising, check that the lifting saddle and weight are in the right position.
Secure the object with lashing straps.
Repeatedly use the foot pedal to lift the object. Make sure that the locking bar tip locks into a
notch of the frame properly, when the desired height is reached.
Stabilise the jack lift on an even surface by adjusting the stabilisation screw.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 50799
Page 4
11 2020-1

Advertisement

Table of Contents
loading

Table of Contents