Advertisement

Quick Links

SPAR-11
Instruction manual
DE – ACHTUNG: Die Verwendung des INNOTECH-Produkts ist erst zulässig, nachdem die
Gebrauchsanleitung in der jeweiligen Landessprache vollständig gelesen und verstanden wurde.
EN – ATTENTION: Use of the INNOTECH product is permitted only after the instruction
manual has been read and fully understood in the respective language.
IT – ATTENZIONE: L'utilizzo del prodotto INNOTECH è permesso solo previa lettura e
comprensione dell'intero manuale di istruzioni nella lingua del relativo paese di utilizzo.
FR – ATTENTION : L'utilisation du produit INNOTECH n'est autorisée qu'après avoir
entièrement lu et compris la notice d'utilisation dans la langue du pays concerné.
NL – ATTENTIE: Dit INNOTECH-product mag pas gebruikt worden nadat u de gebrui-
kershandleiding in de taal van het betreffende land gelezen en begrepen hebt.
SV – O B S : Denna INNOTECH-produkt får inte användas förrän bruksanvisningen på
respektive lands språk har lästs igenom och förståtts.
DK – GIV AGT: Du må først bruge et produkt fra Innotech, efter du har læst og forstået
brugsvejledningen i fuldt omfang i dit lands sprog.
ES – ATENCIÓN: Se autorizará el uso de los productos INNOTECH una vez que se hayan
leído y entendido las instrucciones de uso en el idioma del país.
PT – ATENÇÃO: O uso do produto INNOTECH apenas é permitido depois de ter lido e
compreendido na totalidade as instruções de uso na respetiva língua nacional.
PL – UWAGA: Produkty firmy INNOTECH mogą być używane dopiero po dokładnym
zapoznaniu się z całą instrukcją obsługi w ojczystym języku.
TR – DİKKAT: INNOTECH ürününün kullanımına ancak ilgili ülkenin dilinde sunulmuş
olan kullanım kılavuzunun tamamen okunmasından ve anlaşılmasından sonra izin verilir.
SL – POZOR: Uporaba izdelka INNOTECH je dovoljena šele po tem, ko ste navodila preb-
rali v celoti v ustreznem jeziku svoje dežele in jih tudi razumeli.
CZ – POZOR: Práce s výrobkem INNOTECH je povolena teprve po kompletním přečtení a
porozumění návodu k použití v jazyku daného státu.
SK – POZOR: Produkt INNOTECH môžete používať až po prečítaní a porozumení celého
návodu na použitie pre príslušnú krajinu.
HU – FIGYELEM: Az INNOTECH termékek használata csak azt követően engedélyezett,
hogy saját nyelvén elolvasta és megértette a teljes használati utasítást.
注意:只有在仔细阅读并完全理解了当地语言的使用说明后,才能使用 INNOTECH 公司的产品。
ZH –

Advertisement

Table of Contents
loading

Summary of Contents for Innotech SPAR-11 Series

  • Page 1 SV – O B S : Denna INNOTECH-produkt får inte användas förrän bruksanvisningen på respektive lands språk har lästs igenom och förståtts. DK – GIV AGT: Du må først bruge et produkt fra Innotech, efter du har læst og forstået brugsvejledningen i fuldt omfang i dit lands sprog.
  • Page 2: Table Of Contents

    DESCRIPTION OF SYMBOLS SAFETY INSTRUCTIONS COMPONENTS/MATERIAL INSPECTION WARRANTY APPROVAL SIGNS & MARKINGS [10] DIMENSIONS [11] INSTALLATION TOOLS [12] INSTALLATION SUBSTRATE [13] INSTALLATION [14] LOAD DIRECTIONS [15] DISPOSAL [16] ACCEPTANCE LOG [17] RESTRAINT SYSTEM INSTRUCTIONS [18] TEST LOG [19] DEVELOPMENT & SALES SPAR-11/180226/www.innotech.at...
  • Page 3: Description Of Symbols

    WARNING For a POTENTIALLY dangerous situation that could lead to minor physical injuries and damage to property. CAUTION Supplementary information/Instruction  ü correct incorrect Wear protective gloves! Wear safety spectacles! Comply with manufacturer's instructions/applicable instruction manuals. SPAR-11/180226/www.innotech.at...
  • Page 4: Safety Instructions

    The restraint system may be installed only by experts familiar with the roof safety system and in compliance with the current state of the art. When installing/using the INNOTECH "SPAR-11" anchorage device, the respective accident prevention regulations (e.g.: working on roofs) must be complied with.
  • Page 5 NOT guaranteed. Attachment to the INNOTECH "SPAR-11" is always made with one carabiner through the rotating anchorage eye, and this must be used with personal protective equipment in accordance with EN 361 (safety harness) and EN 363 (fall arrest system).
  • Page 6: Components/Material

    COMPONENTS/MATERIAL INNOTECH "SPAR-11-50" A) Instruction manual B) Lubricant: Weicon AntiSeize ASW 10000 C) Anchorage eye: Stainless steel AISI 304 D) M16 Lock nut: Stainless steel AISI 304 E) Hex nut M16: Stainless steel AISI 304 F) 2x Washer M16: Stainless steel AISI 304 G) Hex bolt M16x70 mm: Stainless steel AISI 304 INNOTECH "SPAR-11-125"...
  • Page 7: Use

    G) Threaded rod M16x250-550 mm: Stainless steel AISI 304 INTENDED INNOTECH "SPAR-11" was developed as an anchor point for personal safety for 3 people (including 1 person for first aid use) and is suitable for the following fall protection systems in accordance with EN 363:2008:...
  • Page 8: Inspection

    If necessary, the product must be replaced. INSPECT ANNUALLY Have INNOTECH "SPAR-11" checked at least once per year by an expert who is familiar with the safety system. The user's safety depends on the effectiveness and durability of the equipment.
  • Page 9: Warranty

    INNOTECH assumes neither responsibility nor warranty in the case of improper use. APPROVAL INNOTECH "SPAR-11" was tested and certified as an anchorage device as per EN 795:2012 TYPE A CEN/TS16415. The notified authority participating in the type test is: DEKRA EXAM GmbH, Dinnendahlstr.
  • Page 10: Signs & Markings

    SIGNS & MARKINGS A) Name or logo of the manufacturer/retailer: INNOTECH B) Type designation: EAP-SPAR-11 C) Signs stating that the instruction manual must be followed: D) Maximum number of persons that can be secured: 3 (including 1 person for provision of first aid) E) Year of manufacture and manufacturer's JJJJ-..-...
  • Page 11: Dimensions

    DIMENSIONS [mm] SPAR-11-50 SPAR-11-125 SPAR-11-200-500 Clamping area = usable thread length less 110 mm Standard length (L): 200/300/400/500 mm (Special lengths upon request) SPAR-11/180226/www.innotech.at...
  • Page 12: Installation Tools

    C20/25, and the use of the original fasteners listed in this instruction manual. DANGER TO LIFE as a result of installation on unsuitable installation substrate. Install INNOTECH "SPAR-11" on statically load-bearing construction concrete (solid concrete) having a concrete quality of at least C20/25.
  • Page 13 INSTALLATION SUBSTRUCTURE: 12.2 WOOD ≥ Wooden formwork ≥ ≥ 12.3 STEEL CONSTRUCTION ≥ ≥ SPAR-11/180226/www.innotech.at...
  • Page 14: Installation

    INSTALLATION 13.1 CONCRETE ≥ ALTERNATING SPAR-11/180226/www.innotech.at...
  • Page 15 INSTALLATION FISCHER compound mortar FIS SB 390 S (INNOTECH "MONT-FIS-SB-390-S") or HILTI HY 200 DANGER TO LIFE if UNAPPROVED adhesives are used. Use only approved adhesives (see section on installation substructure). DANGER Adhere to the setting time! SPAR-11/180226/www.innotech.at...
  • Page 16 INSTALLATION 100 EN 795 ≥ 100 EN 795 ≥ 300 DIBt ≥ 300 DIBt ≥ SPAR-11/180226/www.innotech.at...
  • Page 17 INSTALLATION 13.2 WOOD ≥ Wooden formwork ≥ ≥ 13.3 STEEL CONSTRUCTION ≥ ≥ SPAR-11/180226/www.innotech.at...
  • Page 18: Load Directions

    LOAD DIRECTIONS Concrete EN 795 Concrete DIBt Wood Steel construction DANGER TO LIFE when used in UNAPPROVED load directions. Use INNOTECH "SPAR-11" only in the approved load directions. DANGER SPAR-11/180226/www.innotech.at...
  • Page 19: Disposal

    S P A R - 1 1 ORDER NUMBER: PROJECT: CLIENT:  Specialist: Company address: CONTRACTOR:  Specialist: Company address: INSTALLATION: (ý mark with a cross where applicable) PRODUCT: Item SPAR-11 Year of manufacture/Serial number: ___________ Single anchor point (EAP)  Specialist: Company address: SPAR-11/180226/www.innotech.at...
  • Page 20 FASTENER/PHOTO DOCUMENTATION PRODUCT: Item Year of construction/Serial number: Identification marking of anchorage point (e.g.: INNOTECH "STABIL-STA-10-300", INNOTECH "FALZ-15-45", ...) Installation substrate: (e.g.: solid concrete, quality: C20/25, wood rafter dimension, for sheet metal roofs: roof manufacturer, profile, material, sheet metal thickness, etc.)
  • Page 21: Restraint System Instructions

    If there is strain caused by fall, or if in doubt, the anchorage device must be taken out of service immediately and sent to the manufacturer, or to an expert workshop for inspection and repair. The same applies if there is damage to the anchorage equipment. SPAR-11/180226/www.innotech.at...
  • Page 22: Test Log

    (Description of defects/measures) DOCUMENTATION: Instruction manual Acceptance log/Fastener documentation/ Photo documentation PPE (Personal Protective Equipment against falls from a height): Inspection as per manufacturer's specifications Expiration date Annual inspection performed Not checked (no authorisation) ROOF SEALING: No damage No corrosion SPAR-11/180226/www.innotech.at...
  • Page 23 Acceptance result: The restraint system corresponds to the manufacturer's instruction manual and to the state of the art. Technical safety reliability is confirmed. Comments: ___________________________________________________________ Name: _____________________________ ______________________________ Customer Inspection: contractor (expert who is familiar with the safety system) ___________________________________________ _____________________________________________ Date, company stamp, signature Date, company stamp, signature SPAR-11/180226/www.innotech.at...
  • Page 24: Development & Sales

    DEVELOPMENT & SALES INNOTECH Arbeitsschutz GmbH, Laizing 10, 4656 Kirchham/Austria www.innotech.at SPAR-11/180226/www.innotech.at...

This manual is also suitable for:

Spar-11-50Spar-11-125Spar-11-200-500

Table of Contents