Signal Words; Hazards Of Improper Use - Vestil DCR-880 Series Instruction Manual

rev. 6/7/2018

Signal Words:

This manual uses SIGNAL WORDS to indicate the likelihood of personal injuries, as well as the probable
seriousness of those injuries, if the product is misused in the ways described. Other signal words call attention to
uses of the product likely cause property damage. The signal words used in this manual appear below along with
their definitions.
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or SERIOUS
INJURY. Use of this signal word is limited to the most extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or SERIOUS
INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in MINOR or MODERATE
injury.
Identifies practices likely to result in product/property damage, such as operation that might
damage the product.

Hazards of Improper Use:

Vestil strives to identify all foreseeable hazards associated with the use of its products. However, material
handling is dangerous and no manual can address every conceivable risk. The most effective means for preventing
injury is the application of good judgment and common sense by the end-user.
Serious personal injuries might result from improper or careless use of this product.
 Failure to read & understand the entire manual before using or servicing the product is a misuse of the
product. Read the manual to refresh your understanding of proper use and maintenance procedures.
 DO NOT attempt to resolve any problem(s) with the product unless you are both authorized to do so and certain that
it will be safe to use afterwards.
 DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil. Unapproved
modifications might make the lift unsafe to use and automatically void the Limited Warranty (see p. 25).
 DO NOT exceed the capacity of the drum handler. The product is labeled with its capacity (see Label 287 in
"Labeling diagram" on p. 25).
 Inspect the product as directed in "Inspections and Maintenance" on p. 21-22. ONLY use the drum handler if it is in
normal condition. If repairs are necessary, only install manufacturer-approved replacement parts.
 DO NOT change the setting of the pressure relief valve.
 ALWAYS carefully watch the drum handler and drum during use.
 DO NOT use this device UNLESS all product labels (see "Labeling Diagram") are readable and undamaged AND all
machine guards are in place.
 DO NOT ride on the drum handler or use it to move people.
 ALWAYS lower the carriage until the drum is entirely supported by the ground before leaving the drum handler.
 If part of the hydraulic system is damaged, AVOID contact with pressurized oil. High pressure oil easily punctures
skin which can cause injury, gangrene, or death.
 Unload the drum handler before performing any service work on it.
 The unit should always be labeled as shown in the Labeling Diagram on p. 24. Replace all labels that are damaged,
missing, or not easily readable.
 DO NOT use the drum handler if it cannot firmly and securely clamp the lip of the drum.
 Only use this product on compacted, improved surfaces.
Proper use, maintenance, and storage are essential for this product to function properly.
o Always use this product in accordance with the instructions in this manual.
o Relieve hydraulic pressure whenever the unit is not in use by fully lowering the carriage.
o Keep the product clean & dry. Lubricate moving parts at least once per month.
ONLY use manufacturer-approved replacement parts. Vestil is not responsible for issues or malfunctions that result
o
from the use of unapproved replacement parts.
o DCR-880-H and DCR-880-H-HP: Do not use brake fluid or jack oils in the hydraulic system. If oil is needed, use an
anti-wear hydraulic oil with a viscosity grade of 150 SUS at 100°F, (ISO 32 cSt @ 40°C), or Dexron transmission fluid.
o Contact the manufacturer for MSDS information
Copyright 2018 Vestil Manufacturing Corp.
DCR-880, MANUAL
Page 2 of 25