Stanley SHP 2150 Assembly, Care And Use Instructions page 13

OPERATING INSTRUCTIONS CARE AND MAINTENANCE
CARE AND MAINTENANCE
• Using the nozzle tip cleaner provided (or an
unfolded paper clip), insert the wire into the
nozzle hole and move back and forth until debris
is dislodged.
• Back flush water through the nozzles using
garden hose and highest pressure available
(either standard water nozzle or use your thumb
over the nozzle to create water pressure for back
flush).
93908_16ANR030_2150_ENG-FR-SP.indd 13
Storage
• When your pressure washing session has been
completed, turn off the power switch located
on the front of the power washer. Unplug the
power cord from the outlet. Turn off the water
supply. Pull the trigger on the spray gun 2-3 times
to drain out the excess water and to release any
remaining water pressure. Disconnect the garden
hose adapter from the water inlet.
the power washer to run with no water flowing
through it.
• Remove detergent bottle and clean completely.
Residual chemical will stick to the container and
can cause the detergent injector to clog and not
function properly.
• Remove high pressure hose from spray gun.
• Remove lance from the gun. Place the gun in the
holder on the side. Lances are placed into any of
the slots in the back of the unit. Make sure to
discard any remaining detergent from the bottle.
Flush the bottle and nozzle head with fresh water
to prevent clogging.
• Hook the power cord around the L-shaped tab on
the right side of the machine when facing it.
• The pressure hose is stored on the hose hook
located on the back of the handle.
allow
DO NOT
13
16/12/14 下午5:49