Daintree GE Tetra Contour Manual

Tetra Contour
®
LED Lighting System
GEXNLG15, GERDXNLG15, GEPOXNLG15, GEYAXNLG15, GELGXNLG15,
GEGLXNLG15, GEBLXNLG15
The light guide is made to use together with the light engine. Please ensure you read the installation guide and
warnings of light engine before installing. / Le guide est conçu pour une utilisation de pair avec un module DEL
Contour. S'assurer de lire les instructions d'installation et les avertissements avant de procéder à l'installation.
Step 1:
Preparation
1
Remove the protective film
from the light guide.
Silicone Bend-Aid
4
Fill the entire light guide
channel with the GEXNBA
Silicone Bend-Aid(s) and press
into place. Bend-Aid must be
installed prior to heating and
forming. The GEXNBA Silicone
Bend-Aid is reusable.
WARNING/AVERTISSEMENT
2
Mark the light guide at the
required length, adding 0.5 in.
(13mm) for every 16 in. (406mm)
to account for shrinkage during
the forming process.
WARNING/
AVERTISSEMENT
DO NOT heat and form the light
guide with the light engine installed.
/ NE PAS chauffer le guide alors qu'il
contient le module DEL Contour.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment . This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
This Class [A] RFLD complies w i t h the Canadian standard ICES-005. Ce DEFR de la classe [A] est
conforme à la NMB-005 du Canada.
1
Light Guide
Forming Instructions
3
Cut the light guide to the
required length using a
hacksaw, chop saw (cross cut
or veneer blade only), band
saw, or other appropriate
plastic cutting tool.