For Your Safety - Bosch BL 130I PROFESSIONAL Operating Instructions Manual

bl130i_bu_1609929F17_t.fm Seite 2 Montag, 21. April 2008 4:22 16

For Your Safety

Working safely with this unit is pos-
sible only when the operating and
safety information are read com-
pletely and the instructions con-
tained therein are strictly followed.
Laser radiation of laser class 2
625–645 nm, <1.0 mW,
according to EN 60825-1:2001
Do not look into the laser beam.
Do not point the laser beam at per-
sons or animals.
Because of the narrow concentration
of the laser beam, also pay attention to
where the laser beam is pointed at
longer distances.
The laser viewing glasses (accessory) are not pro-
s
tective glasses against laser radiation. Do not use
them as protective glasses against strong sun light
or in traffic.
Children may use the unit only under the supervi-
s
sion of adults.
Do not remove the warning sign from the unit.
s
Have repairs carried out only by a Bosch After-
s
Sales Service. Never open the unit yourself.
Bosch is able to ensure flawless functioning of the
s
unit only if the original accessories intended for it
are used.
Protection of the Unit
Avoid heavy shocks or falls. After heavy exterior in-
s
fluences on the unit, always perform a precision
check before continuing work (see Section Level-
ling Accuracy).
Do not immerse the unit in water.
s
Do not expose the unit to extreme temperatures
s
and temperature variations (e.g., do not leave in
vehicles).
If the unit is not used for a long period, the batteries
s
must be removed (danger of self-discharge and
corrosion).
1 609 929 F17 • (04.05) T
Charging/Replacing the Batteries
Charging the Battery Pack
Before the first operation, charge the battery pack 7
provided. The battery pack can be charged in the unit
only with the charging unit 30 supplied.
Insert the charging plug of the charging unit 30 into
the socket 9 and connect the charging unit to the
power mains (use an adapter if necessary). On the
charging unit 30, the red indicator lights. The charging
of the empty battery pack takes approx. 10 hours.
➨
Never connect the charging unit 30 without the
battery pack 7 inserted!
The charging process is not automatically ended,
therefore unplug the charging unit from the mains after
successful charging. The charging unit 30 and the bat-
tery pack 7 are protected against overloading.
A new battery or a battery that has not been used for
a longer time produces full power only after approxi-
mately five charge/discharge cycles.
Recharging the Battery Pack
Do not recharge the batteries after each use, other-
wise their capacity will be reduced. Recharge the bat-
tery pack when the battery charging indicator 14
blinks or lights continuously.
To maintain the maximum capacity, the battery pack
should be completely discharged from time to time.
For this purpose, leave the unit switched on for a long-
er time.
When the battery pack 7 is empty, the unit can be op-
erated from the charging unit 30 when it is connected
to the power mains. For this purpose, switch off the
unit, charge the battery pack for approx. 5 min and
switch the unit on again with the charging unit con-
nected.
Changing the Battery Pack
The battery pack 7 supplied can be replaced with oth-
er rechargeable batteries or with alkali-manganese-
batteries.
To remove the battery pack, turn the latch 4 of the bat-
tery compartment to the
battery compartment cover 3. Insert either a new bat-
tery pack, other rechargeable batteries or normal bat-
teries. Pay attention to correct polarisation when in-
serting.
Always replace the complete set of battery. Use only
batteries of a single manufacturer with the same ca-
pacity.
A safety feature ensures that only the battery pack 7
can be charged in the unit. Other rechargeable batter-
ies must be charged outside the unit.
English–2
position and remove the