Table of Contents
Advertisement
2-5. HDD Unit Replacement
Installation procedures
1. Insert a new HDD unit into the slot gently, and press
the levers in the direction of the arrows to lock the
HDD unit.
n
Install the HDD with its CAUTION label facing up.
2. Attach the HDD No.label which has same number as
removed HDD to the front of the new HDD unit.
. HDD No. label : 3-605-401-01
CAUTION
label
HDD No. label
3. See the LCD display, and make sure that the status is
"Stp".
Exit
Disks
: Exchange
>Stop
Start
*1* -2- -3- -4- -5- -6- -7- -8-
Stp Rdy Rdy Rdy Rdy Rdy Rdy Rdy
4. Install the front panel (lower). (Refer to the Section
1-7.)
2-6 (E)
HDD unit
Levers
Starting the HDD
Set the menu select cursor to "Start", and press the ENTER
key.
Exit
Disks
: Exchange
Stop
>Start
*1* -2- -3- -4- -5- -6- -7- -8-
Stp Rdy Rdy Rdy Rdy Rdy Rdy Rdy
The drive will start, and a rebuild operation is automatical-
ly executed when spin-up of the drive is completed.
n
The menu "Service : Disks : Exchange" also enables you
to stop or start up a HDD. The menu "Service : Disks :
Exchange" is used to stop a HDD without "Req" (drive
exchange request).
Select and stop a HDD with extra care. If two or more
HDDs are selected, recording/playback may be disabled.
With a rebuild request for HDD has been generated, if
other HDD is stopped, recording/playback may be dis-
abled.
>Exit
Service
: Disks
Mark
Stop
*1* -2- -3- *4* -5- -6- -7- -8-
Start
Rdy Rdy Rdy Req Rdy Rdy Rdy Rdy
: Exchange
MAV-70
Advertisement
Table of Contents
