Table of Contents
Advertisement
If capacity expansion (loop connection) is implemented
Master unit (ID = 1)
IN OUT
ID switch
From host
controller
BKMA-7040
REMOTE1
for copying
2. Connect the MAV-70s with cables.
ID Setup
Set the ID switches of the BKMA-7040s that are connected to the MAV-70s, starting from 1 to 2, 3, and 4
in order.
n
Setting the ID switch at 9 or higher is invalid.
1-15-2. Setting Up the Menu
If the MAV-70 is the master unit for capacity expansion
Set "Master" in the MAV-70 as follows.
1. Open the "System Setup: Configuration display" menu.
2. Select "Master" using the
3. Select "Reset" using the
If the MAV-70 is used for applications other than capacity expansion
Set "Single" in the MAV-70 as follows.
1. Open the "System Setup: Configuration display" menu.
2. Select "Single" using the
3. Select "Reset" using the
4. Set up the other MAV-70s in the same manner.
1-22 (E)
Expansion unit (ID = 2)
IN OUT
BKMA-7040 for
capacity expansion
BNC cables
IN OUT
BKMA-7040
Copy connection
buttons and press the [ENTER] button.
and
buttons and press the [ENTER] button.
and
button and press the [ENTER] button.
and
button and press the [ENTER] button.
and
Expansion unit (ID = 3)
IN OUT
BKMA-7040
n
The system does not run if the BKMA-7040 for copying is
installed into the expansion unit.
Loop
connection
BKMA-7040
MAV-70
Advertisement
Table of Contents
