Cancel The Setting Of Loop Connection - Sony MAV-70 Installation Manual

1-14. Loop Connection

1-14-3. Cancel the Setting of Loop Connection

Describes the menu setting of standalone use after disconnecting loop connection.
n
Before menu setting, disconnect cables of loop connection.
The following screen are examples of standalone use which have been used as master unit (connected two
expansion unit).
1. Open the "Service : Configuration" menu.
Exit Service : Configuration
>Single
*1* -*- -*- -* - -* - -* - -* - -* -
Master
Sub Mas Exp Exp Off Off Off Off Off
2. Select "Single" using the
Exit
Service : Configuration
>Single
*1* -*- -*- -* - -* - -* - -* - -* -
Master
Sub Raw Off Off Off Off Off Off Off
3. Select "Reset" using the
Single Service : Configuration
Master
*1* -*- -*- -* - -* - -* - -* - -* -
Master
>Reset Raw Off Off Off Off Off Off Off
4. Open the "Service : Logical Format" menu.
5. Select "Excute" using the
format is excuted.
Exit
Service : Logical Format
>Excute
*1* -*- -*- -* - -* - -* - -* - -* -
Raw Off Off Off Off Off Off Off
6. When the logical format is completed, check that the following message is displayed.
Exit
Service : Logical Format
>Excute
*1* -*- -*- -* - -* - -* - -* - -* -
Rdy Off Off Off Off Off Off Off
1-20 (E)
buttons and press the [ENTER] button.
and
buttons and press the [ENTER] button.
and
buttons and press the [ENTER] button, then the logical
and
Remain = 0%
Remain = 100%
MAV-70