Hayward AQUARITE FLO Owner's Manual page 11

9. REDUCING PRODUCTION USING THE COVER
Page 5 of 5
6. CHLORINATION BOOST MENU
7. REDUCED PRODUCTION
8. WATER FLOW ALARM
10. SELECT THE FLOW SWITCH
USE ONLY GENUINE REPLACEMENT PARTS
AquaRite Flo
1. Press and hold the '+' button for 3 seconds to enter the menu dedicated to
chlorination boost.
2. The LEDs light up green.
3. Adjust the boost production using the buttons '+' and '-'.
4. Save the configuration by pressing the '+' button.
From this moment on, production will be maintained for 24h as long as water is
flowing through the unit.
After this time period, the unit will return to its previous production situation.
If the LEDs light up yellow, the unit has not reached the desired production.
This may be due to various factors:
- Lack of salt.
- Scaled-up cell.
- Exhausted cell.
- Low water temperature.
If the 3 LEDs in the centre are flashing red, the unit is not producing.
This means that there is no water flow inside the installation. Check
- Flow switches,
- Configuration (see section 9),
- For correct flow.
1. Connect the cover to the box (see section 4).
2. Press and hold the '-' button for 3 seconds to enter the menu dedicated to
reduction of production.
3. The LEDs light up purple.
4. Adjust to the desired production using the buttons '+' and '-'.
5. The reduction is applied to the production already configured.
6. Save the configuration by pressing the '+' button until you return to the
previous menu.
When the cover contact is closed, the LEDs will automatically light up purple
and prodution will be limited to the programmed setpoint.
1. Connect the mechanical flow switch to the box (see section 4).
2. Press the '-' and '+' buttons simultaneously and hold for 3 seconds to enter
the menu.
3. Select the position using the buttons '+' and '-'.
Position 1: Gas sensor only.
Position 2: Flow switch only.
Position 3: Gas sensor + flow switch.
4. Save the configuration by pressing the '+' button until you return to the
previous menu.
Rev. A