National Instruments FOUNDATION NI-FBUS Hardware And Software User Manual page 25

Do not use a cable longer than 100 m. If you are using a 10 Mbps Ethernet, National
Note
Instruments recommends using a Category 5 shielded twisted-pair Ethernet cable.
© National Instruments Corporation
2. Hook the lip on the rear of the FBUS-HSE/H1 LD onto the top of a
35 mm DIN rail and press the FBUS-HSE/H1 LD down onto the
DIN rail, as shown in Figure 2-11.
1
1 Cover 2 Lip
Figure 2-11. Mounting the FBUS-HSE/H1 LD on a DIN Rail
3. Slide the FBUS-HSE/H1 LD to the desired position along the DIN rail.
After the FBUS-HSE/H1 LD is in position, lock it to the DIN rail by
pushing the rail clip to the locked position, as shown in Figure 2-10.
4. Connect the RJ-45 Ethernet port of the FBUS-HSE/H1 LD to an
Ethernet hub using a standard Category 5 Ethernet cable.
Chapter 2
4
3 35 mm DIN Rail
2-13 NI-FBUS Hardware and Software User Manual
Installation and Configuration
2
3
4 Press on to Rail