Advertisement
(5) Repeat steps (3) and (4) as necessary.
(6) Use the Adding Amp Ch-2 level knob to adjust the strength of the effect you get when you operate the
external control unit.
[right side of figure]
OCT/V system
(1) Connect the OCT/V type synthesizer and MS-02 as shown in the diagram.
(2) Play the lowest note on the keyboard (the note that produces a CV OUT voltage of 0V) and use the
tuning knobs on the synthesizer to adjust the pitch to match an accurate reference
(3) Play the highest note on the synthesizer keyboard (the note that produces the highest CV OUT voltage)
and use the Adding Amp Ch-1 level knob and the Anti Log Amp Frequency knob to adjust the pitch to
match your reference tone.
(4) Use the Adding Amp Ch-2 level knob to adjust the effect you get when you operate the external control
unit.
6) Caution
(1) Before using the Log Amp or Anti Log Amp sections, turn on the MS-02 and let it warm up for about 10
minutes.
(2) Since the MS-02 output may be affected by ambient temperature changes, avoid using near heating or
cooling units.
6) For more accurate tuning
For the most precise tuning results when using the MS-02 Log Amp and Anti Log Amp, we recommend the
Korg Tuning Standard WT-10A.
The WT-10A employs a meter to tell you at a glance whether pitch is accurate or not.
The Korg WT-10A tuner
Specifications
^
1. LOG AMPLIFIER
2. ANTILOG AMPLIFIER
Tuning
Width
Hz/V input (0~15V)
Oct/V Output (-12V~+12V)
Tuning
Width
Oct/V input (-4V~+4V)
Hz/V output (-12V~+12V)
Advertisement
