Advertisement
Using the MS-02 for rough pitch adjustment between two Hz/V type synthesizers
- using the MS-02 for rough pitch adjustment between two Hz/V type synthesizers
(1) Connect synthesizers A and B as shown in the figure above.
(2) Set the controls on both synthesizers so that the octave (scale) selectors are at 8' and the tuning knobs
are set at the center position.
(3) While playing a note in the middle of the keyboard of synthesizer A, adjust the MS-02 Adding Amp Ch-1
level knob so that the pitch of B is the same as the pitch of A. For fine adjustment, use the tuning knobs
on synthesizer B.
Note: Be sure that the Adding Amp's Ch-2 level knob is set at the "0" position.
Using the MS-02 for rough pitch adjustment when playing two Hz/V type synthesizers from one keyboard
Use the setting in figure a to lower the pitch of synthesizer B; to raise the pitch of
synthesizer B, follow figure b when making connections.
- a] rough pitch adjustment between two Hz/V type synthesizers from one keyboard (lowering pitch)
Lowering pitch: [figure a]
(1) While playing the lowest note on the keyboard (the note that produces 0V CV OUT voltage) of
synthesizer A, adjust the Adding Amp Ch-2 level knob so that the pitch of synthesizer B matches that of
A.
(2) While playing the highest note on the keyboard of A (the note that produces the highest CV OUT
voltage), use the Adding Amp Ch-1 level knob to fine tune the pitch of synthesizer B so that it matches A.
(3) Repeat steps (1) and (2) as necessary until the scales are matched.
- b] rough pitch adjustment between two Hz/V type synthesizers from one keyboard (raising pitch)
Raising pitch: [figure b]
(1) While playing the lowest note on the keyboard of synthesizer A (the note that produces a CV OUT
voltage of 0V), use the Adding Amp Ch-1 level knob to adjust the pitch of synthesizer B so that it matches
A.
(2) While playing the highest note on the keyboard of A (the note that produces the highest CV OUT
voltage), use the Adding Amp Ch-2 level knob to fine tune the pitch of synthesizer B so that it matches A.
(3) Repeat steps (1) and (2) as necessary.
Using the MS-02 as a modulation input for pitch bend and vibrato effects with an external control unit
- modulation inputs for pitch bend and vibrato effects
[left side of figure]
Hz/V system
(1) Connect the Hz/V type synthesizer and MS-02 as shown in the diagram on the left of figure 6.
(2) Set the Log Amp controls as shown on the diagram. Set the Adding Amp Ch-2 level knob to "0".
(3) Play the lowest note on the synthesizer keyboard and use the Adding Amp Ch-1 level knob and the Anti
Log Amp Frequency knob to adjust the pitch to match some accurate reference
(4) Play the highest note on the keyboard and use the Anti Log Amp Width knob to adjust the pitch to match
a reference tone, as in step (3).
^
^
^
Advertisement
