Punch-Down Block; Heat Shrink Tube; Setting Cross-Id - Brother P-touch E550W User Manual

EDITING A LABEL

PUNCH-DOWN BLOCK

Labels printed with this mode can be used to identify a type of electrical connection often
used in telephony. There are up to three lines for each block on a single label and you can
enter three lines for each block. In this mode, you can specify the following settings:
• Module Width: 200mm, 50mm-300mm
• Block Type: 4 Pairs, 2 Pairs, 3 Pairs, 5 Pairs, Blank
• Sequence Type:
• Start Value: ---, 1 - 99999
• When "Blank" is selected in "Block Type", "Sequence Type" is set to None.
• When "None" is selected in "Sequence Type", "Start Value" shows "---" and you cannot
set a value. To set the "Start Value" from 1 to 99,999, select either "Horizontal" or
"Backbone".

Heat Shrink Tube

When using Heat Shrink Tube, the HEAT-SHRINK TUBE setting screen
appears when any of the labelling application type keys is pressed.
Label length: Auto, 25mm-999mm
When using Heat Shrink Tube with a width of 5.8 mm or 8.8 mm,
the maximum printing length is 500 mm.
Text: Type in one or more lines of data.
When using Heat Shrink Tube:
• You cannot print frames.
• Portions of some decorative characters may be cut off when a line is broken.
• The printed characters may be smaller than when using TZe tape.

Setting Cross-ID

When creating Cable Wrap or Cable Flag, you can make the Cross-ID printed labels.
1
Press the Cable Wrap or Cable Flag key.
2
Select "Cross-ID" using the
3
Select "On" to using the
4 4
One line: Enter the text and insert "/" or "\" where you want to apply the Cross-ID.
Two lines or more: You can apply the Cross-ID between the lines by pressing the Enter
key to create another line.
Example:
24
Selecting a Labelling Application Type
(None),
or key.
or key.
1 line
(Horizontal),
2 or more lines
(Backbone)