Maintenance And Cleaning - Fein Turbo II X Instruction Manual

OBJ_BUCH-0000000234-002.book Page 23 Tuesday, August 1, 2017 8:47 AM
Repair and customer service.
Before mounting or replacing accessories, pull the mains plug. This preventive
WARNING
safety measure rules out the danger of injuries through accidental starting of
the vacuum cleaner.
Exchangeable parts
If required, you can change the following
parts yourself:
Fleece filter bag, disposal bag, flat-fold filter,
hose, tool adapter, elbow, vacuum tubes,
crevice nozzle, floor nozzle, bristle lips, rub-
ber lips, step adapter, vacuum brushes
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted leads and compo-
nents can cause serious injuries. Have the
required service carried out only through a
FEIN customer service agent.
The current spare parts list can be found on
the Internet under www.fein.com.
Transport
The vacuum cleaner is not suitable for
handling by crane. Do not hang the
vacuum cleaner to a crane hook. Oth-
erwise, you could injure yourself or damage
the vacuum cleaner.
Lock the lockable casters when transporting
the vacuum cleaner in vehicles.
Carry the vacuum cleaner only by the handle,
not by the push bar.

Maintenance and cleaning.

Prior to any maintenance and cleaning, dis-
connect the vacuum cleaner from the power
source (pull mains plug).
Check the connections, seals and hoses.
Have damages repaired only through a
qualified repair person and only using original
FEIN replacement parts.
To clean the vacuum cleaner, use commer-
cially available, non-scouring cleaning agents
and water. After cleaning, allow the vacuum
cleaner to dry completely.
Empty the container each time after using
and remove coarse debris and dust.
Empty the container after vacuuming liquids.
Afterwards, run the vacuum cleaner with the
accessories connected for several minutes in
order to dry them.
Dispose of used flat-fold filters and filter bags
according to statutory provisions.
When replacing the vacuum cleaner's cable is
required, have this carried out by FEIN or by
an authorized customer service agent for
FEIN power tools, in order to avoid hazard-
ous situations.
Have a dust-technical inspection carried out at
least once every year by the manufacturer or
an instructed person, e.g. for damage of the
filter, function and tightness against leakage of
the vacuum cleaner as well as function of the
control device.
For vacuum cleaners that were in contami-
nated environments, the exterior as well as all
machine parts should be cleaned or treated
with sealants. When performing maintenance
and repair work, all contaminated compo-
nents that cannot be cleaned to satisfactory
must be disposed of. Such components must
be disposed of in impermeable plastic bags
conforming with the valid regulations for the
disposal of such waste.
For maintenance on behalf of the user, the
vacuum cleaner must be disassembled,
cleaned and maintained as far as feasible, with-
out causing a risk for the maintenance person-
nel or other persons. Prior to disassembly,
the vacuum cleaner should be cleaned in
order to prevent any risks.
The room/enclosure in which the vacuum
cleaner is disassembled should be well venti-
lated. Wear personal protective equipment
during maintenance. After the maintenance,
the maintenance area should be cleaned.
en
23